Confidential User manual Model Name: NNT-TG05 By Emerson Digital Cold Chain, Inc. Revision History Revision 1.
INTRODUCTION: This document provides a basic functional and operational description of Global PCBA- NNT-TG05. Operational instructions, capabilities and hardware features are elaborated. Block diagram and visual references are provided as a supplement. PRODUCT OVERVIEW AND IMPACT SUMMARY: NNT-TG05 is a PCBA that provides features such as location, temperature, vibration, and optic sensing.
Operating conditions: Maximum operating temperature is 50 Degrees Celsius. Minimum operating temperature is -20 Degrees Celsius. Communication Interface: I2C protocols. SPI. UART OPERATIONAL INSTRUCTION: Initialization: NNT-TG05 is initialized by pulling the tab from the main power switch. Upon initialization, a Blue LED serves as a “network status indicator”. A brief description of blue LED indicator is bulleted below.
NNT-TG05 contains peripherals that are used to provide invaluable information to the end user. Optic sensing, temperature, humidity, G force detection and location services are all provided to the end user by a customer User Interface. The optic sensor provides information regarding changes in illuminance, and also serves as a mean of security if utilized in a standard environment that is devoid of light.
Features Frequency Band Description GSM/GPRS: 900/1800 LTE B1/3/8/20/28 31 dBm for GSM/GPRS 900 Max. TX power 30 dBmfor GSM/GPRS 1800 24dBm for LTE B1/3/8/20/28 List of the Followed Test Standards for Assessment of RED Requirement Hereby, Emerson Digital Cold Chain, Inc. declares that the radio equipment NNT-TG05 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://europa.
mobile device. And the following conditions must be met: 1. This Modular Approval is limited to OEM installation for mobile and fixed applications only. The antenna installation and operating configurations of this transmitter, including any applicable source-based time- averaging duty factor, antenna gain and cable loss must satisfy MPE categorical Exclusion Requirements of 2.1091. 2.
expected to have the capability to access information in that form. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.
This device is intended only for OEM integrators under the following conditions: (For module device use) 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.
Plaque signalétique du produit final Ce module émetteur est autorisé uniquement pour une utilisation dans un dispositif où l'antenne peut être installée de telle sorte qu'une distance de 20cm peut être maintenue entre l'antenne et les utilisateurs. Le produit final doit être étiqueté dans un endroit visible avec l'inscription suivante: "Contient des IC: 10124A-101019 ".
