User's Manual

Page 15
J-400 Series
7.0 Spa Fill Up Procedure

PROCEEDING WITH THIS PROCEDURE.
1. Prepare The Spa For Filling
Clear all debris from the spa. (Although the spa shell has been •
polished at the factory, you may want to treat it with a specially
formulated spa cleaner.) Consult your authorized Jacuzzi dealer
for additional information prior to lling spa.
Remove both ProClear™ • Plus skimmer and polishing lter lids
and lters as illustrated in section 13.1 (pages 64-65).
2. Fill Spa
Place the end of your garden hose into empty skimming lter •
bucket (lter bucket on your left) as you stand next to the spa.
Fill spa half way, then place the garden hose into the opposite
lter bucket (lter bucket on your right) while adding the
remaining ll water.
CAUTION: Never ll with water from a water softener. If your
water is extremely “hard”, it is preferable to ll half-way with
hard water and the rest of the way with softened water. Or,
you may ll entirely with hard water if you use a special water
additive available from your authorized Jacuzzi dealer.
Fill spa• until water level is above all jets and just touching
the bottom of each headrest in its lowest position. DO NOT
OVERFILL!
IMPORTANT: Always ll your spa through both lter buckets
after draining. Failure to do so may cause air to be trapped
in either pump, preventing the pump from circulating water.
Remove the hose and replace both lter cartridges as
illustrated in section 13.1 (pages 64-65).
3. Turn On Power
Turn on power to spa at the home’s circuit breaker. The heater and
lter/circulation pump will automatically activate. If the LCD display
shows a “COOL” or “ICE” error, this is normal. Refer to page 71 for
additional information.
4. Activate Jets Pumps
Turn on all jets(s) pumps when adding chemicals
in step 5 (see section 10.2, page 46 to activate
jets).