smartTouch™ Swipe User Manual Doc No.
Copyright © 2015 by Embed International Notice of Rights All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without prior written permission of Embed. For more information on getting permission for reprints and excerpts, contact Embed. Notice of Liability The information in this document is distributed on an “as is” basis, without warranty.
Table of Contents LIST OF ACRONYMS .............................................................................................................................................. 2 SAFETY INFORMATION ........................................................................................................................................ 3 PROTECTING AGAINST ELECTROSTATIC DISCHARGE .................................................................................................
Safety Information This guide assumes that the installer is qualified to work on electrical devices, with electronic skills and experience working with arcade machines. Do not use in life critical or applications requiring high reliability The smartTouch Swipe is not intended for use in systems that may affect human life or that require a very high degree of reliability such as medical equipment, nuclear facilities, aerospace equipment or transportation equipment.
Introduction This manual describes the requirements and steps needed to successfully install the smartTouch Swipe. The scope of this document covers the hardware installation and the interface to common Video game type. Major Components The smartTouch Swipe The smartTouch Swipe is the guest facing device that features a touchscreen display with a dedicated contactless type cards type reader. Guests will Swipe their card for the primary purpose of transacting at games and attractions.
Picture shows typical mounting of device on a game Recommended Installation Hardware The following is a recommended range of hardware to securely install and mount the smartTouch Swipe reader. The smartTouch Swipe reader uses 4mm brass inserts in the base of the enclosure so the appropriate length 4mm metric screws must be used to properly secure the smartTouch Swipe reader. All other hardware can be adjusted to what is most appropriate and available in your area.
Pre-Installation Before the installation of any hardware, verify the following: An adequate earth connection point exists in the game cabinet. If the mounting surface is metal, that it is adequately earthed.
smartTouch Swipe Reader Installation The smartTouch Swipe reader is best mounted and fixed to a location on the game that ensures it’s easily accessible to guests. In many cases it’s recommended to mount the smartTouch Swipe reader over the existing coin entry point as it is readily accessible and allows use of the existing hole for cable entry. The smartTouch Swipe reader display is usually mounted in landscape display orientation.
Template for the smartTouch Swipe reader mount point drill holes. NOT TO 1:1 SCALE This template is available in scale PDF format from support@embedcard.com www.embedcard.
Video Game Installation Standard type Video Games are typically strait forward to install with connections to the 12v DC Power Supply and Credit Input only. From start to finish you can expect to take 25-35 minutes. Harness Required The harness required for this installation is the “Standard Video Harness”.
If +12 v DC is not available from the game or is unstable then you will need to install a dedicated +12v DC 1000mA supply. Note: it’s very important the DC Ground of the new power supply is commoned with the existing DC Ground of the existing in game power supply. Without this common ground ant ticket or coin monitoring will not operate correctly. Game Credit Connections Pin number 7 8 Wire Colour ORANGE/BLACK YELLOW/BLACK Wire Function CREDIT 1 N.O. CREDIT 1 COM. Note “N.O. means “Normally Open”, “COM.
Basic Configuration of the smartTouch Swipe As with any configurable electronic device, the smartTouch Swipe contains settings that either control or change its behaviour without modifying hardware or software associated with the device. The smartTouch Swipe has an integrated Wi-Fi module. The smartTouch is configured to attach to the networking and security information with the use of a special staff card. How it works The smartTouch Swipe is very simple to use .
FCC Part 15B Compliance Statement RADIO AND TELEVISION INTERFERENCE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Version History V 0.0 V 0.1 Initial document Add typical installion picture www.embedcard.