Installation Instructions

Table Of Contents

Battery and Charging

This is a 79 channel 2.4 GHz radio, The radio is powered with an 18650 battery. The

radio comes with the battery installed; however if a reinstall is needed make sure the

negative side is on the side touching the spring of the radio. The radio can be charged

with a micro usb cable attached right below the speaker and power button.

Operation

Power

Power on and off by holding the power button for 2 seconds. When the radio is turned

on, the green light is always on, indicating that the battery is fully charged. When the

red light is on, the battery voltage is lower than 3.5V. When the red light flashes and

the buzzer alarm indicates that the voltage is lower than 3.3V. Need to charge the

radio immediately.

Binding

The radio comes already bound to easypilot in the ready to fly kit. If binding is

necessary follow these steps:

1. Make sure the easypilot and radio are powered off.

PAGE 1
Battery and Charging This is a 79 channel 2.4 GHz radio, The radio is powered with an 18650 battery. The radio comes with the battery installed; however if a reinstall is needed make sure the negative side is on the side touching the spring of the radio. The radio can be charged with a micro usb cable attached right below the speaker and power button. Operation Power Power on and off by holding the power button for 2 seconds.
PAGE 2
. Press and hold the radio throttle trim down and pitch trim down buttons on the radio and turn easypilot on. When the green light flashes quickly then release all buttons . 3. Bring the radio and the easypilot close and power on the easypilot then the green light of the radio will steady light. 4. Power off the easypilot and power on again, the bind is completed. Trim There are trim buttons for each axis on each gimbal. Each trim adjustment will beep the radio and a longer beep indicate the center trim.
PAGE 3
FCC Warning Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.