transporter goggles manual

Tinyhawk

Goggles

Battery and Charging

The battery cartridge comes preinstalled with a 18650 battery. If a battery reinstall is

required please use caution making sure to install with the correct polarity. The

battery can be charged in the cartridge with a micro USB cable. When the battery is

emax-usa.com

charging the indicator light is green. The indicator light will turn red when charging is

complete.

Assembly

Minimal assembly is required for proper operation of the goggles. Follow the steps

below.

1. Attach the two supplied antennas by screwing them on to the SMA

connection point.

2. Place the battery cartridge in the sleeve on the backside of the head strap.

3. Feed the power lead through the loop on the top side of the head strap and

plug in the power lead to the port on the goggles. This will power the goggles.

4. Please remove antennas and power lead when traveling/storing the goggles.

PAGE 1
Tinyhawk Goggles Battery and Charging The battery cartridge comes preinstalled with a 18650 battery. If a battery reinstall is required please use caution making sure to install with the correct polarity. The battery can be charged in the cartridge with a micro USB cable. When the battery is emax-usa.com charging the indicator light is green. The indicator light will turn red when charging is complete. Assembly Minimal assembly is required for proper operation of the goggles. Follow the steps below. 1.
PAGE 2
Operation Power Power on the goggles by plugging in the power lead from the battery cartridge. Power off by unplugging the power lead from the battery cartridge. Video Channel Selection There are 2 buttons (CH and FR) that can manually select the correct channel and frequency band. The table below shows the channel and frequency band map with the respective frequency number. This is the recommended way to change channels to the correct frequency on tinyhawk.