User's Manual

ManualsBrandsElster Solutions ManualsElectronicsELSTER LIGHTING INTELLIGENCE

Description

Part of the DimOnOff wireless control technology, Litenode relays are suitable for general purpose

lighting control applications that add intelligent functions and networkability to any light fixture. The

relay provides continuous retroactive 0 V to 10 V (sink/source) for all types of ballasts and drivers and

provide power to external sensors (optional).

• intelligent distributed control, metering, and monitoring

• NEMA C136-41

• 5- and 7-pin with continuous retroactive 0 V to 10 V dimming

Operation

Unless otherwise programmed, the relay will turn on the fixture approximately 10 seconds after power

is restored to the relay.

The yellow LED will blink when power is properly applied.

Using DimOnOff software, test the communications link with the relay.

Before you install

• This device is to be installed and/or used in accordance with appropriate electrical codes and

regulations.

• If you are unsure about any part of these instructions, consult a qualified electrician.

• Use this device only with NEMA C136-41 or C136-10 certified receptacles.

Use authorized utility procedures to install or ser vice this device. Dangerous voltages are present.

Disconnect power at the circuit breaker or fuse when servicing, installing, or removing the light fixture.

Equipment damage, personal injury, or death may result if safety precautions are not followed.

Litenode™ wireless node

Single load RME-GEN

Installation instructions

IL42-5047A

DRAFT

Summary of content (4 pages)

PAGE 1
DRAFT Litenode™ wireless node Single load RME-GEN Installation instructions IL42-5047A Description Part of the DimOnOff wireless control technology, Litenode relays are suitable for general purpose lighting control applications that add intelligent functions and networkability to any light fixture. The relay provides continuous retroactive 0 V to 10 V (sink/source) for all types of ballasts and drivers and provide power to external sensors (optional).
PAGE 2
DRAFT Litenode™ wireless node 2 Installation Use authorized utility procedures to install or service this device. Dangerous voltages are present. Disconnect power at the circuit breaker or fuse when servicing, installing, or removing the light fixture. Equipment damage, personal injury, or death may result if safety precautions are not followed. If you are uncertain about any part of these instructions, consult a qualified electrician. The node input and output are low voltage (24 VDC).
PAGE 3
DRAFT Litenode™ wireless node 3 Antenna location and installation The antenna for the model ELIR1 Lightnode relay is integral to the unit and is contained wholly within the device itself. It is not accessible to the user and may not be modified in any way. To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation of 20 cm or more should be maintained between the antenna of this device and persons during device operation.
PAGE 4
DRAFT Litenode™ wireless node 4 WARNING (PART 15.21) Changes or modifications not expressly approved by Elster could void the user's authority to operate the equipment. This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. COMPLIANCE STATEMENT (FCC PART 15.