User's Manual
www.elpas.com
Page 1 of 2
DE6329_V3_09/13
VisAccess RDR-PXT (USB)
Reader for Proximity Key Enrollment
Installation Guide
1. INTRODUCTION
The RDR-PXT is a proximity reader designed for batch
enrollment of proximity keys in the PC. It allows easy
inclusion of non-contact ID key reading into AXSAlert
software. The reader transmits the key data 4 times
(every 100 ms) when key is presented to reader. Key
data is accompanied by checksum error detection code
for higher reliability. The RDR-PXT connects to the PC
using a USB port.
2. TECHNICAL SPECIFICATIONS
Technology: RF/ID (Passive RF transponder)
Frequency: 125 kHz
ID codes: 10
12
unique combinations (1 trillion)
Read range: 40-60 mm (2 - 3 in.)
Reading time: 100 ms
Size (H x W x H): 115 x 73 x 29 mm (4-1/5 x 2-7/8 x 1-1/8 in)
Weight: 120 gr (4.2 oz)
Cable length: 1.5 m (5 ft)
Connector: USB
Interface to host: USB
Current drain: 30mA
Temperature range: 0C - 50C (32F - 130F) - indoor use only
3. INSTALL THE SOFTWARE
Insert the AXSalert CD in to the CD-ROM drive; wait a few seconds. The installation setup will start automatically.
If the setup does not start automatically, click Start and select Run. In the field that appears, enter D:\Install.exe
(where D is the letter of your CR-ROM drive).
Follow the instructions that appear on the PC screen.
After installation is completed, connect the RDR-PXT to a USB port on your computer.
34. START THE SOFTWARE
Double click on the AXSalert icon on the desktop
A prompt will appear to insert username and password. Type "admin" (password is not needed) in the user name
field and click on "Login" button.
4. ENROLL NEW CARDS (USERS)
Press on the "users" button: On the "Users" screen select the "+" sign. The "User Properties" screen will appear:
Present the Tag / Cards to the RDR-PXT, the "PIN Code" field will change to a four figure number, if it
doesn’t, retry.
Type the "First name / Last name" of the cardholder
Select "OK"
The cardholder can now use his Tag / Card.
NOTE: To enroll another Tag / Card, repeat the above step
s.
Attention: Do not connect the RDR-PXT before installing the software