USER MANUAL Elo Touch Solutions RFID FOR ET3201L/ET4201L AND ET7001L User Manual– IDS 01 SERIES RFID Rev A, Page 1 of 3
For ET3201L and ET4201L Touchmonitors for: Product Number: RFID MODULE FOR IDS01 Module Part Number: E031451 Locate and remove the access door on the back of the monitor. Connect the RFID antenna wire and the USB cable from the monitor to the peripheral board. Place the board in the position where the access door was. Secure the board into place with the provided screws. For ET7001L Touchmonitors: Connect the RFID peripheral to the available USB connection on the side of the monitor.
Secure the RFID reader with the provided screws.
APPENDIX FCC & Canadian Department of Communications This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
APPENDIX Manual information that must be included The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the users manual of the end product which integrate this module. The end user manual shall include all required regulatory information/warring as show this manual.
APPENDIX FCC Warning Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules.