NOTIFAI CO2 Sensor Model: ELT-100006 INSTRUCTION MANUAL The NotifAi ELT-100006 is designed for professional installation by NotifAi trained installation engineers. Please refer to this instruction manual for important limitations of use and disposal information.
Introduction The ELT-100006 CO2 is designed for indoor use, to be used as part of the Ell-iot cloud sensor platform and used with the ELT-100004 Hub. The Ell-iot dashboard will provide notifications of abnormal sensor readings and battery low warnings.
Installation Instructions Installation by Ell-iot trained engineers only. The hub can be table or wall mounted. Use the supplied bracket to wall mount Firmly push hub onto the bracket This way up Screw holes Use the supplied screws to screw the bracket to the wall Release point Use a flat bladed screwdriver to release the hub from the bracket.
Operating Instructions Installation by Ell-iot trained engineers only.
FCC Compliance Statement for Model No. ELT-100006 This Statement is part of the User Manual Caution: This marking indicates that the user should read all included documentation before use. Retain this supplement for future reference Users of this product are cautioned to use accessories and peripherals approved by Ell-iot Inc.
U.S.A. Digital Emissions Compliance This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
CE Compliance Statement Caution: This marking indicates that the user should read all included documentation before use. Retain this supplement for future reference Users of this product are cautioned to use accessories and peripherals approved Ell-iot Inc The use of accessories other than those recommended, or changes to this product that are not approved by Ell-iot Inc, may void the compliance of this product and may result in the loss of the user’s authority to operate the equipment.
Radiation Exposure Statement Warning: This equipment complies with International Commission on Non-Ionizing Radiation Protection (ICNIRP), IEEE C95.1, Federal Communications Commission Office of Engineering and Technology (OET) Bulletin 65, Canada RSS-102, and European Committee for Electrotechnical Standardization (CENELEC) limits for exposure to radio frequency (RF) radiation.