Maintenance Instructions

Installation Step 2: Congure the EXM2 System

NOTE: EXM2 systems using consisting of a monitor and one Panel Mount or Joystick, a

handheld with gateway, a position display, and an E14x or E16X actuated valve do not require

conﬁguration. EXM2 monitors come factory set for CAN termination and must be at the extreme

end of the main CAN line. See options for CAN wiring and termination on page 14.

The following is a list of reasons why a system would require conﬁguration via Wi-Fi:

• Need maximum travel limits to be different than factory setting

• Reversing monitor controls

• Setting priority or controller for override by primary, secondary, or number

• Reversing valve operation when using an EBXJ valve

• Group number used for multiple monitors on system

• Valve ID change for multiple valves

• CAN address for special system of not using Elkhart Brass controls

• Valve closure before stowing monitor need to be turned off

If the system requires configuration, please refer to the EXM2 System Configuration Manual

(P/N 98612000) for configuration instructions. You can find the most current manual at