Installation Sheet

ManualsBrandsElkay ManualsCountertop OrganizersCrosstown 11.875-in W x 16.75-in L Plastic Dish Rack

PAGE 1

4400BFFR_FTN_A LK4400BFFR_FTN_A

1000003953 (Rev. B - 03/20)

Owners Manual

Model 4400BFFR Tubular Bottle Filler Fountain

with Sanitary Freeze Resistant Single Valve Control Assembly

4400BFFR Fountains are among the easiest to install Fountains on the market today. To assure

you install these models easily and correctly, PLEASE READ THESE SIMPLE INSTRUCTIONS

BEFORE STARTING THE INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE

WITH PLUMBING, ELECTRICAL, AND OTHER APPLICABLE CODES. After installation, leave

these instructions with the Fountain for future reference.

INSTALLER

VALVE WATER LINE SUPPLIED

WITH A 1/4 x 1/2 NPT CONNECTOR

WATER INLET LINE

( BY INSTALLER )

DRAIN LINE BY INSTALLER

( AS REQUIRED BY LOCAL CODES )

(6) 1/2" (13mm) DIA. HOLES

EQUALLY SPACED ON A

12" ( 305mm ) BOLT CENTER

SEE DETAIL A

CONCRETE SLAB

102mm

14"

356mm

203mm

30"

762mm

44 1/16"

1119mm

14 9/16"

371mm

76mm

10"

254mm

64 1/16"

1627mm

Summary of content (10 pages)

PAGE 1
4400BFFR_FTN_A LK4400BFFR_FTN_A Owners Manual Model 4400BFFR Tubular Bottle Filler Fountain with Sanitary Freeze Resistant Single Valve Control Assembly E G C H A /16" 7mm INSTALLER 4400BFFR Fountains are among the easiest to install Fountains on the market today. To assure you install these models easily and correctly, PLEASE READ THESE SIMPLE INSTRUCTIONS BEFORE STARTING THE INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE WITH PLUMBING, ELECTRICAL, AND OTHER APPLICABLE CODES.
PAGE 2
4400BFFR_FTN_A LK4400BFFR_FTN_A INSTALLATION INSTRUCTIONS IMPORTANT ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON IMPORTANT! INSTALLER PLEASE NOTE. THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO WATER LINES IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY OCCUR AWAY FROM THE BUILDING.
PAGE 3
4400BFFR_FTN_A LK4400BFFR_FTN_A SUGGESTED SITE PREPARATION DETAIL FOR THE 4400BFFR FTN. WHEN USING THE SANITARYFR1 VALVE 1-1/2" DRAIN TUBE (SUPPLIED BY INSTALLER) 4" PVC 1/4 BEND (SUPPLIED BY INSTALLER) 4" PVC PIPE (SUPPLIED BY INSTALLER) CONCRETE SLAB CLEANOUT PLUG FOR ACCESS (SUPPLIED BY INSTALLER) 4" 102mm MIN. 8 INCH INSIDE DIA. PVC PIPE, TRIM TO DESIRED LENGTH (SUPPLIED BY INSTALLER) 36" MIN. (914mm) 60"MAX. (1524mm) FROST LINE PVC 8" x 8" x 4" COMBINATION "Y" & 1/8 BEND REDUCING ASSY.
PAGE 4
400BFFR_FTN_A LK4400BFFR_FTN_A SUGGESTED SITE PREPARATION DETAIL FOR THE 4400BFFR FTN. WHEN USING THE SANITARYFR1 VALVE (6) 1/2" (13mm) DIA. HOLES EQUALLY SPACED ON A 12" ( 305mm ) BOLT CENTER 1-1/4 DRAIN TUBE SUPPLIED WITH FTN. AIR GAP ASSY. SUPPLIED WITH VALVE O 14" 356mm O 10" 254mm 3" 76mm 14 9/16" 371mm 64 1/16" 1627mm SEE DETAIL A 30" 762mm 1-1/2 DRAIN TUBE SUPPLIED BY INSTALLER 44 1/16" 1119mm A Detail A CONCRETE SLAB 8" 203mm 4" 102mm FIG.
PAGE 5
4400BFFR_FTN_A LK4400BFFR_FTN_A E G C H A FOUNTAIN CONNECTIONS PLUMBING CONDUIT (BY INSTALLER) TO VALVE FIG. 3 INSTRUCTIONS FOR CONNECTING TUBES FROM VALVE TO FOUNTAIN Step 1 - Insert the 1/8” O.D. tube (Label A) into the connector (provided with fountain). Insert the 1/8” O.D. tube coming from the fountain push button actuator into the connector. Trim any excess length. Step 2 - Secure the 1/8” O.D. tube (Label C) to the waste line assembly. This line is a vent line and should be open to the air.
PAGE 6
4400BFFR_FTN_A LK4400BFFR_FTN_A 5 6 5 4 3, 11 13 6 12 14 14 2 10 FIG. 4 1000003953 (Rev. B - 03/20) FIG.
PAGE 7
4400BFFR_FTN_A LK4400BFFR_FTN_A The Following Items are included with the SanitaryFR1 Valve PARTS LIST ITEM NO. PART NO. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 NS 110175443890 45806C 50986C 56082C 56092C 56123C 56185C 75653C 1000003970 56218C 98678C 70817C 70828C 75639C 75652C 70683C DESCRIPTION Hex Nut - 3/8-16 Single Valve Regulator Holder Regulator Nut Poly Tubing - 1/4” (Cut To Length) - To Bubbler Poly Tubing - 1/8” (Cut To Length) - To Actuator Canister Nylon Strap - 6 ft. Air Gap Assy.
PAGE 8
4400BFFR_FTN_A LK4400BFFR_FTN_A TROUBLESHOOTING AND MAINTENANCE Insufficient Bubbler Flow: Check that the shut-off valve is wide open. Verify minimum 20 PSI supply pressure. Clean inlet strainer screen located in the valve body. Clean rubber orifice in flow control located below frost line in bushing between barb fitting and valve. No Flow: Check for leaks in the air tubing going from the push button to the valve. Make sure the air tubing compression nut is hand tight.
PAGE 9
4400BFFR_FTN_A LK4400BFFR_FTN_A INSTALLATION INSTRUCTIONS IMPORTANT ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON IMPORTANT! INSTALLER PLEASE NOTE. THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO WATER LINES IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY OCCUR AWAY FROM THE BUILDING.
PAGE 10
4400BFFR_FTN_A 21, 22 25 LK4400BFFR_FTN_A 27 45 33 21 16 13 43 25 38 SEE NOTE 13 28 22 29 20 8 28 29 22 24 24 63 61 27 11 62 17 22 37 48 22, 23 28 30 29 63 20 18 61 34 22, 23 52 OR 48 37 11 61 61 Included with Sanitary Valve 62 SEE NOTE 5 49 3 62 42 20 62 REV.