INSTALLATION / OWNER'S MANUAL Two Handle Bar Faucet Model # LK2477CR Groove joint pliers Wrench (2) 1/2 in Supply Lines Screwdriver SAVE FOR CONSUMER Sealant Tape Plumber's Putty
WARNING: Please carefully read and properly follow the instructions for installation found in this manual. STEPS: 1 2 Shut off water supply at angle stop. Remove old faucet.Clean sink surface in preparation for new faucet. Place gasket (1) on bottom of new faucet. Place faucet through mounting holes in sink. Secure faucet to sink using mounting nuts (2) provided. 1 Make connections to water lines. Use 1/2" IPS faucet connections (1) Use wrenches to tighten connections. Do not overtighten.
CARTRIDGE REPLACEMENT 1 2 2 1 3 4 4 3 Turn off water before proceeding! Remove index(1). With valves in "closed" position,unscrew fastener (2) and remove handle (3) from valve stem (4). 5 6 Shut off water supply.Remove handle(refer to step 1).Loosen bonnet (1) by turning it counter-clockwise and lift out the cartridge (2).Inspect the rubber valve seat (3) inside body (4).Make sure the wings (5) on the two sides of the cartridge bonnet fit well into the slots (6) on the body.Tightly bonnet (1).
WARRANTY ELKAY LIMITED LIFETIME WARRANTY Elkay warrants that all parts and finishes of the Elkay Residential brand faucets are free from defects in materials and workmanship for the life of the product, if purchased after 1996. This warranty extends to the original consumer purchaser of the product only. If the product should leak or drip during normal use, Elkay will provide, free of charge, a replacement cartridge.