Performance Data Sheet

ManualsBrandsElkay ManualsKitchen AccessoriesElkay WaterSentry Plus Filter Kit for Elkay EZH2O Bottle Fillers

PAGE 1 98523C (Rev. SIF - 02/16)

IMPORTANT NOTICE: Read this Performance Data Sheet and compare the capabilities

of this unit with your actual water treatment needs. It is recommended that, before

purchasing a water treatment unit, you have your water supply tested to determine your

actual water treatment needs.

NOTICE: Do not use with water that is microbiologically unsafe or of unknown quality

without adequate disinfection before or after the system.

CAUTION: Use on cold water line only. Do not allow installed lter to freeze.

NOTE: Performance will vary depending on local water conditions. While testing was

performed under standard laboratory conditions actual performance may vary.

NOTE: This system and installation shall comply with applicable state and local

regulations.

NOTE: Filter must be used with lter monitor for 3000 gallon rating.

LIMITED WARRANTY

The ELKAY

WaterSentry

Plus is warranted to be free from defects in material and

workmanship for a period of one year from the date of installation. Warranty is limited

to repair or replacement of defective component.

Capacity

Flow Rate

Temperature

3000 Gallons

1 Year Maximum

1.5 GPM

40-100° F (5-38° C)

RECOMMENDED USE CONDITIONS

Maximum Pressure 105 PSI (7.4 Kg/cm

)

Minimum Pressure 20 PSI (1.4 Kg/cm

)

Elkay

WaterSentry

Plus

Lead, Aesthetic Chlorine Taste & Odor & Particulate Class I Reduction

Filter Part No. 51300C FOR EWF3000 - WaterSentry

Plus

FOR COMMERCIAL USE ONLY

PERFORMANCE DATA SHEET

Your Authorized Representative

Buyer

Seller

The Elkay

Watersentry

Plus lter is certied by WQA to NSF/ANSI 42 and 53 for the reduction

of Aesthetic Chlorine, Taste and Odor, Particulate Class I, and Lead, as veried and substantiated

by test data.

Instructions For Installing Replacement Filters

IMPORTANT NOTE - To avoid danger of an electric shock

hazard, disconnect power to your unit before installing or

 replacingthelter.

1. Turn off water supply; dispense water to relieve pressure

2. Turn used lter counterclockwise 1/4 turn to remove from lter head.

3. Remove cap from new lter and use to seal used lter.

4. Insert new lter into existing lter head and turn fully clockwise.

5. Turn on water supply and run a minimum of two gallons of water

through the lter to purge air and ne carbon particles from lter.

Also run water through glass ller (if provided).

Summary of content (2 pages)

PAGE 1
Elkay WaterSentry® Plus ® Lead, Aesthetic Chlorine Taste & Odor & Particulate Class I Reduction Filter Part No. 51300C FOR EWF3000 - WaterSentry® Plus FOR COMMERCIAL USE ONLY PERFORMANCE DATA SHEET ® The Elkay® Watersentry Plus filter is certified by WQA to NSF/ANSI 42 and 53 for the reduction of Aesthetic Chlorine, Taste and Odor, Particulate Class I, and Lead, as verified and substantiated by test data.
PAGE 2
Performance Test Conditions NSF/ANSI 42 NSF/ANSI 53 Aesthetic Chlorine Particulate - Class I Taste and Odor Reduction Lead Reduction Capacity 3000 Gallons (11356 l) Flow Rate 1.5 gpm (2.8 l/m) Pressure 60 psi (4.2 kg/cm2) Temperature 68-70o F (20-21o C) This system has been tested according to NSF/ANSI 42 and 53 for reduction of the substances listed below.