Installation Guide

Ensure the sink drain line
is routed into the waste
tank (6 gallon white tank)
and the connections tight
on both ends.
Fill fresh water tank
(5 gallon blue tank) and
insert both the pump
supply line and hot water
tank pressure release line
into the top opening.
Use only potable water in
fresh water tank.
Plug water pump
electrical cord (black
cord) into GFCI outlet in
rear of cabinet.
Verify water heater
electrical cord is
Unplugged.
DO NOT plug in the
heater until the fresh
water tank is full and
the system has been
purged of air.
INSERT
WASTE LINE
INTO WASTE
WATER TANK
SINK DRAIN
1
STEP
2
STEP
PRESSURE
RELEASE LINE
PUMP
SUPPLY
LINE
3
STEP
PUMP
ELECTRICAL
CORD
GFCI
OUTLET
Plug optional faucet A/C
adapter cord into GFCI
outlet in cabinet.
4
STEP
GFCI
OUTLET
5
STEP
Plug unit into outlet (1PH,
60HZ, 20A, 120V circuit).
If water pump does
not start running, press
the “reset” switch on
GFCI outlet.
OPTIONAL
FAUCET A/C
ADAPTER
WATER
HEATER
ELECTRICAL
CORD
GFCI
OUTLET
6
STEP
SETUP INSTALLATION INSTRUCTIONS
CABINET
ELECTRICAL
CORD
WALL OUTLET
MINIMUM
20 AMP CIRCUIT
REQUIRED
FRESH
WATER
TANK
Touchless Handwashing Station
(5/20) 1000005815
HAVE TOUCHLESS HANDWASHING STATION QUESTIONS? REACH OUT - WE’RE HERE TO HELP - 800-260-6640