Installation Sheet

INSTALLATION
ATTENTION INSTALLER:
1. Make cutout using electronic DXF file.
2. Locate and drill the mounting holes (following
the countertop manufacturer’s instructions) as
shown below. Holes should allow even spacing
of mounting brackets around the sink. Type of
fasteners to be as recommended by countertop
supplier.
3. Fasten mounting brackets (optional accessory-
LKUCLIP8) to countertop loosely.
4. Using a good quality silicone caulk, apply a bead
evenly all around the top of the sink flanges.
5. Position and align sink over the countertop
opening. Press silicone onto countertop.
6. Tighten fasteners until mounting brackets are
snug against sink.
7. Check alignment of sink to countertop opening.
8. Tighten down fasteners evenly. Be careful not to
overtighten. Remove excess silicone.
DXUH 1/8” OVERHANG AND 1/2” REVEAL
COUNTERTOP INSTALLATION
COUNTERTOP
MOUNTING
BRACKET
(OPTIONAL
ACCESSORY)
SINK
SILICONE CAULK
(NOT FURNISHED)
COUNTERTOP
OVERHANG
APPROX. 1/8”
1/8” COUNTERTOP OVERHANG
1) ELKAY RECOMMENDS THAT UNDERMOUNT SINKS SHOULD BE INSTALLED BY A PROFESSIONAL
EXPERIENCED INSTALLER.
2) WARNING: THE ELECTRONIC TEMPLATE (DOWNLOAD DXF FILE FROM WWW.ELKAYUSA.COM) WILL
CREATE AN OVERHANG OF APPROXIMATELY 1/8" OR A REVEAL OF 1/2”. IT IS RECOMMENDED THAT
YOU DISCUSS THIS WITH YOUR CUSTOMER AND AGREE THAT THIS FINISHED APPEARANCE IS THE
DESIRED EFFECT. ELKAY IS NOT RESPONSIBLE FOR IMPROPER SINK OR COUNTERTOP
INSTALLATIONS. DUE TO THE AESTHETIC QUALITIES OF THE CONVERGING BOWL RADII, THE DXF
TEMPLATE PROVIDES THE ONLY OPENING RECOMMENDED FOR INSTALLATION OF ELKAY
UNDERMOUNT SINKS. SEE ILLUSTRATION BELOW.
3) ELKAY UNDERMOUNT SINKS SHOULD ONLY BE FASTENED TO A SOLID SURFACE COUNTERTOP
(I.E. GRANITE/CORIAN
®
/SILESTONE
®
).
4) ELKAY IS NOT RESPONSIBLE FOR SINK OR COUNTERTOP IF DAMAGED DURING INSTALLATIONS.
5) METAL EDGES MAY BE SHARP - USE CAUTION WHEN HANDLING.
6) FOLLOW ALL LOCAL PLUMBING AND BUILDING CODES.
7) INSPECT SINK FOR DAMAGE PRIOR TO BEGINNING INSTALLATION.
1/2” COUNTERTOP REVEAL
COUNTERTOP
MOUNTING
BRACKET
COUNTERTOP RECESSED
APPROX. 1/2"
SILICONE CAULK
(NOT FURNISHED)
SINK
1-1/8"
FASTENER
(NOT FURNISHED)
FASTENER
(NOT FURNISHED)

Summary of content (2 pages)