Installation Instructions

EFTLB332210CDBL Sink
Installation Instructions
STEP ONE
Position sink on countertop. Take into consideration
adequate clearance for the faucet, backsplash, and any
accessories such as a soap/lotion dispenser.
STEP TWO
Cut countertop opening following the countertop manu-
facturer’s recommended instructions.
STEP THREE
Test cutout by placing the sink into the cutout.
STEP FOUR
Install faucet(s) (not included), drain(s) (not included)
that will be connected to sink following the appropriate
manufacturer’s recommended instructions.
From the sink underside, locate the channel slots. Push
clamps into the designated channel slot based on the
countertop thickness as shown in the channel profile.
Rotate the clamp as necessary to install the sink into the
countertop.
STEP FIVE
Clean underside of sink flange and sealing surface of
countertop opening thoroughly to remove dirt or
residue. Thoroughly dry and apply a continuous bead of
a high quality silicone adhesive caulk (not furnished) to
the underside of the sink flange near the edge. Position
sink into countertop opening.
STEP SIX
Rotate the clamp to engage the countertop as shown in
the installation profile. Tighten screw until sink is securely
fastened and flush, without gaps to the countertop.
STEP SEVEN
Remove any excess caulk and allow to properly cure fol-
lowing caulk manufacturer’s recommended instructions.
STEP EIGHT
Install supply lines, drain fittings and other items. Run
water and check for leaks.
CAREFULLY READ THESE INSTRUCTIONS BEFORE YOU BEGIN
• Elkay is not responsible for sink or countertop if damaged during installation.
• Metal edges may be sharp – u
se caution when handling.
• Follow all local plumbing and building codes.
• Inspect sink for damage prior to beginning installation.
• The clamps provided are designed for a maximum countertop thickness of 1-1/2".
SCREW
SINK
SILICONE CAULK
(NOT FURNISHED)
COUNTERTOP
(1-1/2" MAXIMUM
THICKNESS)
C-CLAMP
Cutout in Countertop (1-1/ 2" radius in corners)
Length Width
Model Left-to-Right Front-to-Back
EFTLB332210CDBL 32 3/8” 21 3/8”
WIDTH
LENGTH
1-1/2" RADIUS ON
ALL 4 CORNERS
Installation Instructions
Installation Profile
Recommended
attachment location
for a 3/4" countertop
thickness
Recommended
attachment location
for a 1-1/2" countertop
thickness
Channel Profile