Cut Sheet

PO Box 100 • Hildebran, NC 28637 • 800-797-9355 • 828-397-4200

Fax 828-397-4415 • www.elkproducts.com • info@elkproducts.com

Power Distribution Modules

These Power Distribution Modules conveniently

distribute a single A.C. or D.C. input into nine

individual outputs, for centrally powering Video

Cameras, PIRs, Photobeams, etc. Each output is

protected with an auto-resetting PTC to protect a

shorted output from disabling the other outputs. A

visual LED power indicator is provided for each

output along with a single Master Power On/Off

Switch. The modules accept a 6 to 30 Volt A.C. or

D.C. power source (not included) which connects

either to the input terminal block or the 2.1mm D.C.

power jack located on the module. Two or more

outputs can be paralleled for additional current.

• Auto-Resetting (PTC) Overload Protection (NO FUSES to REPLACE).

• Master Power On/Off Switch.

• Visual LED Power Indicators on each Output.

• Convenient Test Points for measuring Total Current Draw.

• Lifetime Limited Warranty.

• Paintable White Plastic

• Max Current Draw: PD9 = 250mA from each output.

PD9HC = 400mA from each output.

• Max Combined Current Draw: Not to Exceed Input Power Source.

• Input/Output Voltage: 6 to 30 Volts A.C. or D.C.

• Input Connection: Screw Terminals or 2.1mm Plug-In D.C. Jack.

• Output Connection: Screw Terminals (POS and NEG) for each Output.

• Enclosure Size: 6.5" x 4.3" x 2".

ELK-PD9 250mA rated outputs

Features

Specifications

Kit Part Numbers

PD9AC24 AC Camera Kit: Includes ELK-PD9 + ELK-TRG2440 24V AC, 40VA Transformer.

PD9DC12 DC Camera Kit: Includes ELK-PD9 + ELK-P1216 12V DC, 1.5A Plug-in Power Supply.

ELK

PRODUCTS, INC.

ELK-PD9HC 400mA rated outputs

PAGE 1
Power Distribution Modules ELK-PD9 250mA rated outputs ELK-PD9HC 400mA rated outputs These Power Distribution Modules conveniently distribute a single A.C. or D.C. input into nine individual outputs, for centrally powering Video Cameras, PIRs, Photobeams, etc. Each output is protected with an auto-resetting PTC to protect a shorted output from disabling the other outputs. A visual LED power indicator is provided for each output along with a single Master Power On/Off Switch.
PAGE 2
ELK-PD9 Instructions 1. To remove the cover from the Power Distribution Module (ELK-PD9), use a small object like a screw driver to press into the slots located on the end of the cover. Insure that the power switch is off. 2. Using Table 1 or Table 2 below, select an AC or DC Power Source that provides enough current to power the number of devices to be used. The Power Source voltage must also match the device's voltage requirements.