Installation Guide

Assembly Instructions for BF10

Cold Valve Body

Hot Valve Body

O-ring

Rubber Washer

Metal Washer

Mounting Nut

Cone Washer

Friction Ring

Supply Line Nut

FAUCET INSTALLATION:

1.Shut off the water supply valves before installation.

2.Unscrew the mounting nut, and remove the metal washer and

rubber washer from the hot valve body. From the top, install the

hot valve body into the left faucet hole. From underneath, place

the rubber washer, metal washer, and thread the mounting nut

onto the threaded shank and tighten tight.

3.Repeat step 1 for the cold valve body.

4.Connect the supply lines (not included) to the threaded shanks.

5.After installation in completed, turn on the water supply valves

and allow both hot and cold water to run at least one minute

each. While water is running, check for leaks, especially at

hook-ups to supply lines. Tightening nuts slightly will stop any

minor leaks.

NOTE: WRAP AT LEAST 3 LAYERS OF TEFLON TAPE ON ALL THREADED CONNECTIONS

Cross Handles:

1.Put the cross handles on the broaches and

then tighten the screws.

2.Insert the caps on the cross handles.

Caps

Screw

Cross Handle

Broach

Rev.E

Elizabethan

Classics

CAUTION: DO NOT OVER TIGHTEN NUTS - THIS CAN LEAD TO STRIPPING OR

CRACKING AND WILL VOID YOUR WARRANTY.

AND SCREWS

NOTE: TO BE INSTALLED ONLY BY QUALIFIED, LICENSED PLUMBER