FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Any changes or modifications not expressly approved by the party responsible for End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: "Contains FCC ID: WL6-TC6BC30CA1 Notice: This device complies with Part 15 of the FCC Rules.
body. Information for the OEMs and Integrators The following statement must be included with all versions of this document supplied to an OEM or integrator, but should not be distributed to the end user. 1) This device is intended for OEM integrators only. 2) Please see the full Grant of Equipment document for other restrictions.
Connectors and Pads 4 1 Audio FPC Connector 2 Battery Pad 3 WiFi/BT/GPS Antenna Pad 4 RF Test Connector 5 TP Connector
6 LCD Connector 7 Speaker Pad 8 Mic Pad 9 T-flash Card Connector 10 Side Key Connectors 11 Bear Camera Connector 12 Front Camera Connector 13 Micro USB Connector Main components A CPU+PMIC+DDR+EMMC B WiFi/BT C CODEC D GPS .
gain 6 2.