Tension Electric Screen Elite CineTension Series USER’S GUIDE Matte White/High Contrast Grey/High Gain Rev 1.
IMPORTANT SAFETY INSTRUCTIONS 1. Carefully unpack the screen. 2. Position the power cord so it will not be tripped over, pulled, or near a hot area or surface. 3. To avoid an electric shock, do not attempt to disassemble this appliance yourself. 4. Do not attempt to use the screen if there are obvious damages or broken parts to avoid injury and/or an electric shock. 5. Please disconnect the power supply when screen is not in use for a long time. 6.
INSTALLATION 1. Select the location for your screen projector and access to a good power source. For best results follow your users manual of your projectors recommended distance settings. 2. For the best support of your screen, it is ideal to secure the screen (see example page) into the studs of your house’s internal framework. If you are installing the screen into a dry wall you will require dry wall anchor. For concrete mounting you will require concrete anchors. 3.
Examples Of Installation & End Cap Dimensions Page L” Bracket Mounting a Flush wall Mounting b 1. Start by locating the studs on your wall. Make sure to measure the keyholes located on the back end of the screens end caps. 2. Mark the area where screw hole will be inserted for the L” bracket or screen. The L” bracket is sold sepperatly. 3. Setup (a) is a well example for mounting the screen using the L: bracket. 4. Setup (b) is another example for mounting the Screen flushing it against the wall. 5.
Remote control and 3 & 4 prong wire information . This is the IR (Infra-Red) remote with a range of 15 Ft. The Battery Size is 23A 12V. . This is the RF (Radio Frequency) remote with a range of 30 Ft. Control box The 3 prong wire will come from the outlet and the 4 prong cable goes directly to the screen. The directional buttons are located on the side of the control box.
OPERATION Remote Control System And Wiring: Line Switch: Manual 3-way wall switch for your new Elite Screen with wireless IR and RF remote. 1. This is the control box connection to your new Elite Screen. First insert the 3-prong cable (Pins) to the proper input of the control box. Then connect the cord with the 4prong cable (Pins) into the proper output of the control box. The other end of the 4prong cable (Pins) will need to go to the screen’s case. Please see example diagram.
Vertical Limit Switch Adjustment (Attention: This adjustment is not required. Always contact an Elite Screen Technician for assistance to avoid damaging the screen and voiding your warranty. *Important Note: It is strongly advised that the user not ever adjust the Vertical Limit Switch. All screens have already been pre-adjusted in the factory to meet the multitude of user needs. Description of this feature was included for those rare situations that require it.
TROUBLESHOOTING If the electric screen does not move, please check the following: 1. 2. 3. 4. Check the power supply and fuse first. The screen will not move without power. Make sure the power cord is plugged to the power outlet. Check all cable connections to see if any may be disconnected. If the screen works well with the line switch but not with the remote control, please make sure the remote controls have batteries or replace them with new ones. FAQ’s 1.
Warranty Policy - Electric Screens • • • • • • One (1) year warranty parts and labor from purchase date as follows (except for refurbished units as specified below) Refurbished units carry a 90-day parts and labor warranty. Demo units or open box items carry a full 1-year parts and labor warranty. Each party will be responsible for one way shipping during the warranty period.
REGISTER YOUR ELITE PRODUCT TWO WAYS TO REGISTER YOUR WARRANTY WITH ELITE SCREENS INC. A. On Line (Faster and Easier) www.elitescreens.com /register.html B. Fill out & Fax to (562) 483-8498, Attn: Customer Service Dept.