Installation Guide

Page 9

Water Main Shut-O Advanced User Manual

Physical Installation

Review the Pre-Installation Checklist below to make sure the Water Main Shut-Off

can be used for your application. The device should already be included in your

Z-Wave system before continuing further.

Pre-Installation Checklist

9 The Water Main Shut-Off can be installed on any 1/2” to 1-1/2” brass ball

valve

9 Make sure the VALVE HANDLE is comfortably usable by hand prior to

installation

9 The valve should be 5” away from any walls or other obstructions (Figure

9 Make sure the OPEN/CLOSE BUTTON is accessible in the final position

9 Make sure there is a working power outlet (that will always be powered on)

reachable with a 10’ cord from the valve

9 Finally, confirm that you are still within range of your Z-Wave controller.

5”+

5”

HOSE CLAMPS

VALVE HANDLE

Figure 4 - Water Main Shut-O Installation

Physical Installation

PAGE 1
Physical Installation Review the Pre-Installation Checklist below to make sure the Water Main Shut-Off can be used for your application. The device should already be included in your Z-Wave system before continuing further.
PAGE 2
Installation Process 1. Make sure the installed valve is comfortably usable by hand before continuing further. 2. Open both HOSE CLAMPS completely so their ends are free, insert both of them into the slots in the MOUNTING BRACKET, and let them hang loosely. 3. Remove the protective film covering the screws on the CONTROL ARM and spread the CONTROL ARM. 4.
PAGE 3
Centers are aligned Figure 6 - Proper Alignment of the Water Main Shut-Off ball valve, and tighten the HOSE CLAMPS until the Shut-Off is completely secure (Figure 5.) 7. Squeeze the CONTROL ARM closed around the valve handle and secure it CAUTION It is absolutely critical that the axes for both the valve and Water Main Shut-Off are aligned. Improper installation will result in unreliable performance. Examine Figure 5 for more details and please visit www.domeha.