User's Manual

Usermanual



1． Functionalschematicdiagram



2.Instructions

1)changecolor

manually .

Pressthebutton“MODEL”toturnon,akindofcolorlight,pressthisbuttonordinaltocontrol

theAmbientlightforchangingcolors(changesevencolormost).Pressthebuttoneighthtime

toturnoff(otherbuttons

to lose effectiveness).



2)changecolor

automatically .

Press the button “MODEL” to turn on, hold on two seconds, Enter the automatic mode. Now

the

Ambientlightwillchangecolorautomatically every five seconds. Press the button “UP” to

speed up the speed of changing color, when press the button fifth, the

Ambient light will

changecolor

automatically every seconds. Press the button “DOWN” decelerate the speed

of changing color, when press the button fifth, the

Ambient light will change color

automatically every seconds.

3)Press the button “MODEL” again, turn back to the a kind of color mode, now change color

manuallyandpressthebutton“UP”toturnonsoundcontrol,then

the Ambientlightwillflash

andchangecolor

automatically according to the music. Press the button “MODEL” again, it

will flash in a kind of color. When it is flashing, press the button “MODEL” continuously to

enter “

changecolormanually” mode.

PAGE 1
User manual 1． Functional schematic diagram 2. Instructions 1) change color manually . Press the button “MODEL” to turn on, a kind of color light, press this button ordinal to control the Ambient light for changing colors (change seven color most ). Press the button eighth time to turn off (other buttons to lose effectiveness). 2) change color automatically . Press the button “MODEL” to turn on, hold on two seconds, Enter the automatic mode.
PAGE 2
User manual 2． Functional schematic diagram 2.Instructions 1) Press the button “OPEN” on the remote, the TV Mount will extend and stop. 2) Press the button “LEFT,RIGHT,DOWN” want. to adjust the angle that you 3) Hold the button “MEMORY” long time and adjust the angle you want, then press the button “MEMORY” again, the red light turn off and this angle is saved.
PAGE 3
FCC ID: VII-SMMAL-T-1 IMPORTANT REGULATORY INFORMATION This device complies with Part 15 of the FCC Rules: Operation is subject to the following two conditions: 1. This device may not cause harmful interference and 2. This device must accept any interference that is received, including any interference that may cause undesired operation. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipments.