Instruction Manual Mouser Thank you for your support Please read the instruction manual carefully before operating Please keep the instruction manual for future reference Elexa Consumer Products, Inc.
Product Introduction Mouse zapper is an intelligent security equipment that can transmit the Z-Wave network which has particular frequency. Different countries or areas, the radio frequency of Z-wave network is different.In the Z-Wave network communications, mouse zapper can work with any Z-wave main controller. It can send messages to the Z-wave main controller, and realize association with other devices through the Z-wave network, but it can not receive messages from the Z-wave main controller.
Product Configuration Mouse zapper cover Power switch LED light Food box Mouse zapper main body Battery Cover Code button Safety switch Product List Mouser Instruction manual 1pc 1pc
Including Sensor (mouse zapper) to Z-Wave Network The mouse zapper can be included to the Z-wave network by pressing the code button. 1) Disassemble the mouse zapper and insert the battery. Make sure the device locates within the network range of the Z-wave main controller. 2) Set the Z-wave main controller in the learning mode (see main controller’s operating manual). 3) Quickly, triple click the code button, LED diode will flash. 4) Mouse zapper will be detected and included in the Z-Wave network.
Mouse zapper usage Disassemble the mouse zapper Put in food Battery installation Assemble the mouse zapper Disassemble the mouse zapper Take out the food box Take out the mouse zapper cover Battery installation Disassemble the battery cover Put in food Install the battery Assemble the battery cover Assemble the mouse zapper Note: The battery specification of mouse zapper is 1.5v AA size,and there must be 4pcs battery to ensure the mouse zapper works properly.
Tips Make sure the mouse zapper is within the Z-wave network. Do not put the mouse zapper cover in the water,so as not to damage the mouse zapper. The main body and the food box of the mouse zapper can be disassembled for cleaning. When the mouse zapper cover is removed, the safety switch is opened ,and the mouse zapper will not be triggered,so the mouse zapper will not output high voltage.
Restore the Sensor (mouse zapper) to Factory Default Settings Reset procedure will delete all information on the Z-Wave network and Z-Wave controller, and restore the sensor to factory default settings. 1. Remove the device cover. 2. Make sure the mouse zapper is connected to power. 3. Press the reset button for 10 seconds, LED diode will flash. 4. Release the button. NOTE When the mouse zapper is being restored factory settings, please make sure power source is connected. The status of the LED light 1.
Event: Replace Battery Now (0x0B) Note Mouse zapper is powered by battery. Using batteries other than specified may result in explosion. Dispose of properly, please observe environmental protection rules. Advanced Configuration 1. Basic Setting Command When the mouse zapper trigger alarm, it will send basic setting command with parameters. The receiver will execute this parameters.
The mouse zapper stays dormant most of time, in order to conserve battery.
pollution damages caused by malfunctioning software, attack of a computer virus, or by failure to update the software as recommended by the Manufacturer; FCC NOTE： This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
