User's Manual

Thank you for purchasing the DOME
Door/Window Sensor Pro! Use this device with
your Z-Wave Certied Controller to monitor
doors, windows, and other openings in your
home and also to monitor ambient temperature
levels.
Including/Connecting into the Z-Wave Network:
(Door/Window Sensor Pro not yet powered on)
Follow the instructions for your Z-Wave certied Controller to
enter inclusion mode. When prompted by the Controller:
1. For proper inclusion, bring the Door/Window Sensor Pro to
where it will be used.*
2. Remove the Battery Tab.
The LED Indicator will alternate between green and red, then ash
green three times indicating inclusion.
Including/Connecting into the Z-Wave Network:
(Door/Window Sensor Pro already powered on)
Follow the instructions for your Z-Wave certied Controller to
enter inclusion mode. When prompted by the Controller:
1. For proper inclusion, bring the Door/Window Sensor Pro to
where it will be used.*
2. Open the Sensor Cover.
3. Press the Connect/Tamper Button three times and the LED
Indicator will alternatingly ash green and red until inclusion.
The LED Indicator will alternate between green and red, then ash
green three times indicating inclusion.
Key Features
• Z-Wave Plus Certied
• S0 Security-Enabled*
• Built-In Temperature Sensor (off by default)
• Up to 260’ range
• Ten-Year Battery Life
• LED Signal Strength Indication
• 1” Max distance between sensor & magnet
• Ultra-Narrow (1/4”) Magnet for Placement
Between Door and Casing
• Monitor doors, windows, medicine cabinets,
drawers, garage doors, and many other openings
*For non Z-Wave Plus networks, please consult the owner’s manual for your
primary controller to determine the best method and location for adding the
Door/Window Sensor Pro to your Z-Wave network.
*Encrypted communication requires S0-capable controllers.
Excluding/Disconnecting from the Z-Wave Network:
Follow the instructions for your Z-Wave certied Controller to
enter exclusion mode. When prompted by the Controller:
1. Remove the Cover of the Door/Window Sensor Pro.
2. Press the Connect/Tamper Button quickly 3 times in a row.
The LED Indicator will ash three times indicating exclusion/dis-
connection, then start blinking yellow (red + green.)
Resetting the Door/Window Sensor Pro to Factory
Default Settings:
To disconnect from the Z-Wave Network and restore factory default
settings:
1. Open the Cover and make sure the Door/Window Sensor Pro
is powered.
2. Wait 5 seconds.
3. Move the magnet in and our of the closed position 6 times.
4. The LED Indicator will light red for 2 seconds indicating suc-
cessful reset, then start blinking yellow (red + green.)
Only do this if the controller is disconnected or otherwise unreachable!
Door/Window Sensor Pro
DMDP1
SOLIDWORKS Educational Product. For Instructional Use Only.
Screw Holes
LED Indicator
Connect/Tamper Button
Sensor Cover Release Button
Reed Switch
Figure 1 - Main Parts of the Door/Window Sensor Pro