User's Manual

ManualsBrandsEleven Engineering ManualsElectronicsSKAA USB TX

SKAA USER’S GUIDE

(for SKAA OS v2.1)

Each SKAA® receiver uses a Green List to keep track of your favorite transmitters. Using a

favorite transmitter as well as hunting through your favorite transmitters is signaled by a Green

LED. Your receiver can also explore to find new, unknown transmitters. Exploring is signaled by

an Amber LED. If your product has two or more wireless receivers—for example, a left speaker

and a right speaker—that’s called a Cluster and all of its pieces act as one. The SKAA Button on

your receiver lets you control which transmitter you’re listening to (button with

logo).

Essentials

Command

LED Meaning

Click

Favorites Hunt for your favorite transmitters ...

Click again to switch between hunting for all

transmitters on your Green List and only the

current one

(dim) = Hunting

(flash) = Next one

(solid) = Bonded

2 Clicks

Explore Hunt for new, unknown transmitters

(not favorites)

(dim) = Hunting

(solid) = Bonded

Hold

(a few seconds)

Add / Delete Manually add / delete the current

transmitter to / from your Green List

to = Added

(flash) = Deleted

Auto Add SKAA adds the current Amber

transmitter to your Green List if you listen to it

for 30 minutes

to = Added

More Commands

Command

LED Meaning

3 Clicks

Play / Pause Sends /command to the

source device (example: computer or iPod

)

or (1 flash) = command

sent

4 Clicks

Swing Mode Bond to any transmitter on your

Green List (hint: have just one powered on)

(dim) = Hunting

(solid) = Bonded

6 Clicks

Clear the Green List Start over!

(flash) = Green List cleared

Hold during

power on

Make a Cluster of receivers:

1. Make sure the transmitter is powered off

2. Power on the Master receiver while holding

down its SKAA Button—hold the button

down until the Red LED begins to flash

3. With the remaining receivers within 3

meters of the Master receiver, power on

the first one, wait for its Red LED to flash

and then power on the second one.

Continue until all of them are powered on.

4. Once all of the LEDs stop flashing (turn

solid Red), power off all of the receivers

(flash) = Master receiver

has entered

‘Cluster Up’ mode

(solid) = The Cluster has

been successfully

made

Summary of content (3 pages)

PAGE 1
SKAA USER’S GUIDE (for SKAA OS v2.1) Each SKAA® receiver uses a Green List to keep track of your favorite transmitters. Using a favorite transmitter as well as hunting through your favorite transmitters is signaled by a Green LED. Your receiver can also explore to find new, unknown transmitters. Exploring is signaled by an Amber LED. If your product has two or more wireless receivers—for example, a left speaker and a right speaker—that’s called a Cluster and all of its pieces act as one.
PAGE 2
QUESTIONS AND ANSWERS Question Answer How does the Green List work? Every time you add a transmitter, it is automatically assigned the first open spot on the Green List—so if you already have two transmitters on your Green List, the next one you add will go in Green List spot #3. The receiver can hunt through the Green List much like a car radio hunts for radio stations when you press “seek”.
PAGE 3
Compliance Information The statements for SKAA device Model numbers PL5557-S (30-Pin Tx), PL5561-S (USB Tx) and PL5564-S (Lightning connector Tx) are as follows: FCC Statement: Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.