User Manual
UART-RF-Stick 915
28 010 0903 - Integration Manual
138204501_EN_0716
General
Product description
The elero UART RF Stick 915
• is a radio receiver for the elero ProLine 2 radio system.
• serves as a receiver module for devices for home
automation such as drives for roller shutters,
Venetian blinds, curtains or lighting systems and
heater systems.
• is constructed as a PCB device with integrated radio
module and antenna.
• does not have its own housing.
• communicates with the target product via a UART
interface and via the integrated radio module with the
elero ProLine 2 radio system.
• offers the full functionality of an elero ProLine 2 radio
receiver such as automatic functions. The routing
function is also integrated.
Intended use
The elero UART RF Stick 915 can be used in the
intended home automation devices such as drives for
roller shutters, Venetian blinds or lighting systems and
heater systems.
The devices also have a suitable slot for the UART RF
Stick 915.
Exclusion of liability
elero GmbH accepts no liability for injury, damage
or financial losses arising from modifications to the
device, improper use or a failure to observe the operat-
ing instructions. Liability for material defects is exclud-
ed in such cases.
Connection and installation
See operating manual of the target product.
Manufacturer’s
address
Service
elero GmbH
72660 Beuren
GERMANY
www.elero.com
If faults should occur despite
proper operation or if the device
is damaged, contact your dealer
or the manufacturer.
FCC / IC
FCC ID: YBU28010X9X3
IC: 8929A- 280101X9X3
USA (FCC)
Part 15 Statement gem. FCC 15.19/RSS Gen Issue 3
Sect. 7.1.3
This device (elero UART-RF-Stick 915) complies with
Part 15 of the FCC Rules and with Industry Canada
license-exempt RSS standard(s). Operation is subject
to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Canada, Industry Canada (IC)
Le présent appareil (elero UART-RF-Stick 915) est
conforme aux CNR d‘Industrie Canada applicables aux
appareils radio exempts de licence. L‘exploitation est
autorisée aux deux conditions suivantes :
(1) l‘appareil ne doit pas produire de brouillage, et
(2) l‘utilisateur de l‘appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est sus-
ceptible d‘en compromettre le fonctionnement.
Caution:
Changes or modications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
Information:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment gen-
erates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment o and on, the user is encour-
aged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit dif-
ferent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV techni-
cian for help
Technical data
Product designation UART RF Stick 915
Operating voltage [V] DC 2.7 ... 3.0 ... 3.6
Transmission frequency
[MHz]
915 (band)
Transmitting power [dBm] 1 (decibel milliwatt)
Operating temperature range
[
°C
]
0 ... 50
Dimensions [mm] 42.5 x 19.5
Item No. 28 010.0903
Contains FCC ID YBU28010X9X3
Contains IC 8929A-28010X9X3