VENICE 3 SPEED TURNTABLE With USB/SD Card Encoding Read this instruction manual carefully before use and keep for future reference.
SAFETY INSTRUCTIONS 1) READ THIS INSTRUCTION MANUAL BEFORE YOU ATTEMPT TO CONNECT OR OPERATE THE APPLIANCE. 2) KEEP THESE INSTRUCTIONS IN GOOD CONDITION. HEED ALL WARNINGS. FOLLOW ALL INSTRUCTIONS. 3) SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE. 4) THE UNIT SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING AND NO OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, SHALL BE PLACED ON THE PRODUCT. DRY LOCATION USE ONLY. 5) NO NAKED FLAME SOURCE, SUCH AS CANDLES, SHOULD BE PLACED NEAR THE PRODUCT.
Power Supply Plug the AC power cord to a household outlet. Ensure that the output power of the outlet matches the power requirement as indicated on the unit’s rating label. Location of Control A. B. C. D. E. F. G. H. 45 RPM Adaptor Cue-lever, use this lever to lift the tone arm Auto Stop Speed Selector Tone Arm Holder Stylus Power/ Volume Knob Turntable 1. 2. 3. 4. 5. DC Jack Line Out (Right) Line Out (Left) Speaker (Right) Speaker (Left) 6. 7. 8. 9. 10. 11. 12. 13.
Switching the Unit On & Off 1. Power the unit as described above. 2. To turn the unit on, turn the Power/ Volume knob clockwise. 3. To turn the unit off, turn the Power/ Volume knob counter-clockwise to “OFF” position. Volume Control • To increase the volume, turn the Power/ Volume knob clockwise. • To decrease the volume, turn the Power/ Volume knob counter-clockwise. Record Player 1. Place the record on the turntable. If required, also place the adaptor on the record spindle. 2.
Record care and maintenance To ensure the best sound and the least amount of wear on your records, it’s essential that they are kept clean. Make sure your records, especially older ones are sufficiently cleaned prior to playing them thoroughly clean dust off the stylus and record regularly. Use a soft brush to clean the stylus. Brush from the base to the tip as shown below.
• • The reading time for a USB drive varies depending on the speed of the memory device and the number of songs and folders. In some cases the reading time may be as long as 60 seconds. Always switch off the unit before removing a USB flash drive to prevent damage to your USB device. The manufacturer is not responsible for the loss or damage of data. Due to numerous methods of compression it could be that some files or USB flash drives cannot be played.
Unit ON but there is low or no volume Sound is distorted • Headphones are inserted into the Headphone jack • Pull the headphone out • The radio output is muted and volume control has no affect. • Unplug the unit for 3 minutes to reset. • Volume level is set too high • Decrease the volume Technical specification - Model no.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any inte rference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.