Operation Manual

ManualsBrandsElektra ManualsAmplifierE20 - REMOTE CONTROL STEREO PREAMPLIFIER

Instructions For Use. Page 1E20

E20 REMOTE CONTROL STEREO

PREAMPLIFIER

INSTRUCTIONS FOR USE

Thank you for purchasing the Musical Fidelity

Elektra E20 Preamplifier . Used properly and care-

fully, it should give you many years of outstanding

musical reproduction.

The E20 is the result of many years painstaking

research and development. The E20 is designed for

ultra-high definition performance and is equipped

with full remote control facilities.

Aesthetically, the E20 is a perfect match for the

Elektra E30 power amplifier, E50 tuner and the E60

CD player. Together, they form one of the finest hi fi

systems that you can own today.

Dust regularly with a soft duster or soft brush but

do not use cleaning or polishing agents - they may harm

the surface finish.

If you have any questions about anything in your

audio system, please consult your dealer who is there

to help and advise you.

Summary of content (7 pages)

PAGE 1
E20 REMOTE CONTROL STEREO PREAMPLIFIER INSTRUCTIONS FOR USE Thank you for purchasing the Musical Fidelity Elektra E20 Preamplifier . Used properly and carefully, it should give you many years of outstanding musical reproduction. The E20 is the result of many years painstaking research and development. The E20 is designed for ultra-high definition performance and is equipped with full remote control facilities.
PAGE 2
PLEASE READ IMPORTANT! This unit is supplied in the UK with a mains lead fitted with a moulded 13 amp plug. If, for any reason, you need to cut off this plug, please observe the following safety precautions. Please dispose of the cut-off plug safely. It must not be plugged into a mains power supply. The wires in the mains lead supplied with this appliance are coloured in accordance with the following code: Green and yellow..............Earth Blue...............................Neutral Brown..................
PAGE 3
CONNECTIONS AND FACILITIES 7 1 8 2 3 4 9 5 6 FRONT PANEL 1 2 3 4 5 6 7 8 9 A C Power on/off switch Volume control knob Remote receiver lens Tape 2 record selectors Mute indicator Source selector knob LED, indicates volume setting Output to Tape 2 indicators Source (listen) indicators B BACK PANEL D 10 11 12 13 14 15 16 17 18 19 20 21 22 23 REMOTE CONTROL A B C D Remote operation LED Volume Up/Down buttons Source selector buttons Mute Button 10 12 13 14 15 16 17 18 19 20 21 Phono/Chassis
PAGE 4
INSTALLATION INSTALLATION PRECAUTIONS Your new E20 is designed and built to provide trouble-free performance but it is necessary to observe a few precautions. Please ensure that you have complied with them before you connect any AC power to your amplifier. Retain this guide for future reference. þ Heed all warnings on the back of the unit. ý Do not use near water. ý Do not place the amplifier near direct heat sources such as radiators or other equipment that produces heat.
PAGE 5
CONNECTIONS CONNECTIONS All connections should be made with the power OFF. The E20 has inputs for Phono (MM and MC), CD, Tuner, Video, LD, Auxiliary and two Tape decks (1 and 2). TAPE CONNECTIONS Note that the E20 has connections for two tape decks. You could therefore have two tape decks connected at the same time. To listen to Tape 1, select Tape 1 with the source selector, to listen to Tape 2, select Tape 2 on the source selector.
PAGE 6
TROUBLESHOOTING Basic troubleshooting of an amplifier is similar to troubleshooting of any other electrical or electronic equipment. Always check the most obvious possible causes first.
PAGE 7
SPECIFICATIONS ELEKTRA E20 REMOTE CONTROL PREAMPLIFIER Output (Unbalanced) THD Frequency Response Inputs. Input sensitivity Line S/N Ratio Line Tape output Power consumption Power requirements 0.775V < 0.01% 20Hz - 20kHz +/- 1dB 5 Line, 2 Tape, 1 Phono. 250mV/47K >85dB Dependent on input 10 Watts 100-120Volts, AC 50/60Hz 220-240Volts, AC 50/60Hz (Factory Preset for country) MM 3mV, 47K MC 500mV Phono Stage Dimensions WxHxD 440 x 95 x 340mm Height includes feet. 5.2 kgs. 7.0 kgs.