PRELIMINARY INSTRUCTION MANUAL Introduction Congratulation on purchasing this state-of-the-art Atomic Clock, this is a complete system that lets you monitor the temperature indoors and out, also it provide WV radio-controlled time, date, day of week display. Locations Of Control Main Unit MODEL.
Feature ® Receives kHz WV signal. Automatic time and date adjustment after signal reception. Calendar with day of the week display from January 1, 2000 to December 31, 2097 Hour, minutes and second display.
Cautions: ® Use only fresh batteries of the required size and recommended type ® Do not mix old and new batteries, different types of batteries ( standard, alkaline, or rechargeable ). Getting Started To ensure proper functioning of the RF reception from remote unit, please follow this power up procedure. 1. Insert of new batteries into the Main unit and press RESET ( See Batteries installation and batteries replacement ). 2.
Calendar Set At the back of the clock, slide the switch to CALENDAR and the date will keep flashing on the display. Then press the MONTH, DATE and YEAR bunion to set your desired calendar setting and slide the switch to the LOCK position to complete the calendar set. Time zone Set At the back of the clock, slide the time zone switch to desired time zone. Automatic time update The clock will automatically update its time every day at Eastern Standard Time(EST).
it will be automatically converted to the chosen one of the main unit, Remote unit Receiving status indicator The status indicator indicate the following stage of the received signal y-NO SIGNAL DETECTION “3 BH) | signal DETECTING ‘, Fal PH | SUCCESSFUL RECEPTION Losing Synchronization of Remote & Main Unit If the clock is fail to receive the remote unit data after power up or fail to receive the remote data for 5 consecutive times, the remote temperature field display press RE-SYNC to force the receiver to
1. Inside or near concrete/steel buildings or structures, unless the clock is close/next to a window. Next or close to power station 3. Inside moving vehicles ( automobile, train, airplanes etc. ) which radio transmission or electronics will interfere the reception of radio-controlled clock 4. Too close to household appliances ( computer, TV, video/audio, fax machine, speakers ). 5. Near construction sites, traffic lights, roadside, neon lights etc. Close to or on top of metal surface/plates.
The remote unit comes with a wall mount holder which can hold the unit on wall, or just place it on a flat surface. Reset the Clock Press the RESET button when the RF Thermos Clock does not operate normally. Note: Once resetting the RF Thermos Clock, the main unit will start to search remote unit for 5 minutes and start receive the WV signal ( Refer to Getting Started ). Take care of your RF Thermos Clock ® Avoid exposing your RF Thermos Clock to extreme temperatures, water or severe shock.
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of more of the following measures: ® Reorient or relocate the receiving antenna. ® Increase the separation between the equipment and receiver.