Introduction The EL-2635 is a wireless repeater designed to extend the range of wireless devices registered to the infiniti control panel. Up to four repeaters can be registered to the control panel with eight transmitters registered to each repeater. The repeater is powered by either 9VAC (via a 110VAC plug-in step down transformer) or 12VDC with a 6V rechargeable backup battery pack.
Registering Transmitters to the Repeater You can register up to eight transmitters to the EL-2635 repeater. Note: Do not register the same transmitter to more than one repeater. To register transmitters to the repeater: 1. 2. 3. 4. 5. On the LCD programming keypad, press until 4. TX Register appears on the display. Press ; New Device appears on the display. Press again; Transmit 1 appears on the display. Send two transmissions from the device you want to register.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.