REMOTE CONTROL ELECTRONIC DEADBOLT PROGRAMMING & OPERATIONS MANUAL DO NOT THROW AWAY UNTIL YOU HAVE SAFELY STORED YOUR ADMIN CODE
LOCK INSTALLATION INSTRUCTIONS 1. Remove Existing Deadbolt Parts List First things first -- make sure have all of the necessary components in your SimpliciKey package. 1 interior lock 1 interior plate 2 short bolts 2 long wood screws Next, remove the interior and exterior lock components. Finally, take out the existing deadbolt slide assembly. 2 long bolts 2 strike wood screws First, remove the two interior screws securing the lock. 2 short wood screws 1 exterior lock 2.
5. Install New Deadbolt 3. Remove Existing Strike Plate First, remove the two existing strikeplate screws. Remove the strike plate and any other hardware behind the plate. Place deadbolt into door, check to see if cross-hairs are centered. Strike plate To adjust the deadbolt length, twist the deadbolt slide assembly to extend and center in cutout. 4. Install New Strike Plate Install the strike plate, then tighten screws.
Optional wood screw hole for increased security. Plastic clip 7. Install Interior Plate 9. Install Interior Lock Slide wires through wire hole of interior lock plate. Be sure to keep wires out of the way by sliding both wires into the plastic clip on the interior plate. Guide excess wiring into cavity above the green circuit board. Align thumbturn with flat bar to mount to interior plate. (Thumbturn must be in the vertical position and deadbolt must remain retracted).
DAILY USE INSTRUCTIONS REMOTE CONTROL KEYFOB INSTRUCTIONS STOP! Test your keyfobs now before attempting to program. 1. Remote Control Keyfob Critical Point STOP! Test your keyfobs now before attempting to program. SimpliciKey comes factory programmed with the keyfobs included in the package. If the keyfobs are not registered with your lock, or to add additional keyfobs (up to the maximum limit of 8), please see the instructions on page 8.
KEYPAD INSTRUCTIONS KEYPAD INSTRUCTIONS Critical Point Critical Point Your administration code (Admin Code) can be found on the back of this booklet. The Admin Code can be changed by following instructions on page 12. Your administration code (Admin Code) can be found on the back of this booklet. The Admin Code can be changed by following instructions on page 12. Press Command Add Key Code Enter Admin Code 1. Enter your Admin Code, press * A - D - D - C - O - D - E - 2.
CHANGING YOUR USER ADMIN CODE Enter your Default Admin Code (see below) or the existing User Admin Code and press the * key to begin Admin mode. Default Admin Code LOW BATTERY INDICATOR When the 4 (AA) batteries get low, SimpliciKey will emit an alert tone and the low battery indicator LED and exterior LED will flash for approximately 15 seconds. Please be sure to replace your batteries at this time in order to ensure proper operation of SimpliciKey.
INSTRUCTIONS FOR USE: Always purchase the correct size and grade of battery most suitable for the intended use. Clean the battery contacts and also those of the device prior to battery installation. Ensure the batteries are installed correctly with regard to polarity (+ and - ). Remove batteries from equipment which is not to be used for an extended period of time. Remove used batteries promptly.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Troubleshooting Tips: For additional tips and troubleshooting, please visit Question Solution Why are the keyfob buttons reversed? (lock button unlocks, unlock button locks.) Check to make sure the flat bar is horizontal through the cross-hairs during installation. (page 5) Why doesn’t the latch fully extend when I rotate the thumbturn? Check to make sure the flat bar is horizontal through the cross-hairs during installation.