User's Manual

APPENDIX A
REGULATORY INFORMATION
Revised: 20 Feb 07 APX A-1 EST P/N AA107S
INFORMATION TO USERS
The ESTeem Model 195Es complies with Part 15 of the
FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that may
cause undesired operation.
Note to User:
Changes or modifications to this equipment not expressly
approved by Electronic Systems Technology for
compliance could void the user's authority to operate the
equipment.
Other Information
Model 195Es
Direct Sequence Spread Spectrum Device
FCC ID No: ENPESTEEM195ES
Canadian Certification Number: 2163A-195ES
The equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
This device has been designed to operate with the antennas listed below, and having a maximum gain of 7 dBi. The antennas
listed below with 7 dBi gain have permanently attached coaxial cables so that the rf power delivered to the antenna connector
is less than 1 watt. Antennas not included in this list or having a gain greater than 6 dBi are strictly prohibited for use with this
device. The required antenna impedance is 50 ohms. To reduce potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful
communication.
The antennas should be mounted with a minimum separation distance as specified in APPENDIX B - SPECIFICATIONS.
The antennas must not be co-located with other antennas.
ANTENNA TYPE P/N. GAIN(dBi)
Omni-Directional AA20DMEs 2
Omni-Directional Mag-Mount AA191Es 5
Omni-Directional DC Grounded AA20Es900 7
Yagi AA203Es900 7