Specifications

ManualsBrandsElectronic Systems Technology ManualsElectronicsBASE STATION TRANSMITTER

Table Of Contents

Recommended Mounting

APPENDIX B

SPECIFICATIONS

Model 195Eg Specifications

Revised: 16 Jun 06 APX B-1 EST P/N AA107P

LED Indicators

Power On/Off Receiver On/Off

Carrier Detect On/Off Transmitter On/Off

Link Status On/Off

I/O Connectors

Ethernet 10/100Base T RJ-45

RS-232C Programming Port RJ-45

Dual Antenna input/Outputs TNC Reverse Female

Direct Input Power Header Screw Connector

Transmiter

Frequency of Operation

4.960 & 4.980 GHz

Software Selectable with two Channels

RF Data Rates

1,2,5.5,6,9, & 11 Mbps Fixed or Auto Scaling

DSSS/CCK Modulation

Tx Output Power 2 Watts (peak) / 1 watt (average)

RF Output Impedance 50 ohms

Receiver

Rx Sensitivity

-85 dBm @11 Mbps to –92 dBm @ 1 Mbps

Frame Error Rate <10%

Power

Power Connector on Unit 10 to 16 VDC

Receive 320 ma @ 12 VDC

Transmit 1500 ma @ 12 VDC

Case

Dimensions 1.9 in. H x 6.7 in. W x 6.2 in. L

Weight 1.25 lbs.

Outdoor Pole Mounting Kit Optional, EST P/N 195PM

Other

Warranty 1 Year

Temperature Range

-30° to +60° C

Humidity 95% Non-condensing

FCC Type Acceptance Pending Type Acceptance

Specifications Subject to Change Without Notice

Summary of content (6 pages)

PAGE 1
APPENDIX B SPECIFICATIONS Model 195Eg Specifications LED Indicators Power On/Off Carrier Detect On/Off Link Status On/Off Receiver On/Off Transmitter On/Off I/O Connectors Ethernet 10/100Base T RS-232C Programming Port RJ-45 RJ-45 Dual Antenna input/Outputs Direct Input Power TNC Reverse Female Header Screw Connector Transmiter Frequency of Operation RF Data Rates 4.960 & 4.980 GHz Software Selectable with two Channels 1,2,5.
PAGE 2
APPENDIX B SPECIFICATIONS Model 195Eg Case Specifications Revised: 16 Jun 06 APX B-2 EST P/N AA107P
PAGE 3
APPENDIX B SPECIFICATIONS Antenna Specifications Model No: Antenna Type: Applications: Frequency: Polarization: Impedance: Gain: VSWR: Front to Back Ratio: Horizontal Beamwidth: Vertical Beamwidth: Antenna Material: Mounting Hardware: Antenna Connector: Antenna Envelope: Weight: AA191Ep Omni-Directional, Vehicle Mount Mobile 4.9-5.0 GHz Vertical Caution 50 ohms Omni-directional antenna 5.5 dBi should not be located within < 1.5 20 cm of personnel. n/a n/a n/a Black Radome Base Included TNC-R Male 12 in.
PAGE 4
APPENDIX B SPECIFICATIONS Antenna Specifications Model No: Antenna Type: Applications: Frequency: Polarization: Impedance: Gain: VSWR: Front to Back Ratio: Horizontal Beamwidth: Vertical Beamwidth: Antenna Material: Mounting Hardware: Antenna Connector: Antenna Envelope: Weight: AA20Ep Omni Directional, DC Grounded Fixed base 4.9-5.0 GHz Vertical 50 ohms 9 dBi (7dBd) 1.2:1 Typical n/a n/a 40 degrees @ ½ power Brass radiator, UV inhibited fiberglass enclosed Base to Mast, Supplied. TNC-R Male with 36in.
PAGE 5
APPENDIX B SPECIFICATIONS Antenna Specifications Model No: Antenna Type: Applications: Frequency: Polarization: Impedance: Gain: VSWR: Front to Back Ratio: Horizontal Beamwidth: Vertical Beamwidth: Antenna Material: Mounting Hardware: Antenna Connector: Maximum Power Input: Antenna Envelope: Windload (RWV): Lateral Thrust at Rated Wind: Wind Surface Area: Weight: Revised: 16 Jun 06 AA203Ep Directional, DC grounded Fixed base. 4.9-5.0 GHz Vertical or Horizontal 50 ohms 9 dBi (7 dBd) < 1.
PAGE 6
APPENDIX B SPECIFICATIONS Antenna Specifications Model No: Applications: Antenna Type: Frequency: Polarization: Impedance: Gain: VSWR: Front to Back Ratio: Horizontal Beamwidth: Vertical Beamwidth: Antenna Material: AA204Ep Fixed base mounting 2.4 GHz ISM, Directional, DC Grounded, Parabolic Grid 4.9-5.0 GHz Vertical or Horizontal Caution 50 ohms To comply with the FCC exposure 26 dBi (24 dBd) nominal compliance requirements, a < 1.