Manual

Table Of Contents

APPENDIX D

RADIO CONFIGURATION

Revised: 16 Jun 06 APX D-1 EST P/N AA107P

195Ep FREQUENCY OF OPERATION

In a wireless Ethernet network all of the ESTeem Model 195Ep’s must be set to the same radio frequency of operation or channel.

The frequency of operation is selectable when configuring the mode of operation of the 195Ep (reference Chapter 4). See Figure

Figure 1: RF Channel Selection

RF COMMUNICATIONS DATA RATE

The RF data rate of the Model 195Ep can be programmed for operation at 1, 2, 5.5, or 11 Mbps. The RF data rate can be set for a

fixed rate or a specific range that is dynamically scaled by the Model 195Ep from monitoring the received signal quality. By

selecting all ranges from 1 to 11 Mbps you will be able to communicate with all mobile or remote locations devices regardless of

their signal strength.

Dynamic scaling means that the Model 195Ep will operate at the highest RF data rate that is programmed into unit. If the received

data quality drops below the required minimums for reliable communications the Model 195Ep will reduce the data rate to the next

lowest step to increase signal quality. Conversely if the signal quality increases above the minimums the Model 195Ep will

increase the RF data rate the next highest level.

The ESTeem 195Ep is set at the factory to operate at maximized scaling speed data rates from 1-11 Mbps and should not need

adjustment. The RF Data Rate is programmed in the Model 195Ep through the Advanced Menu>Wireless LAN

Settings>Wlan0 Device and the value for wlan0_OPRATES:. In the example shown in Figure 2 the RF Date Rate is

programmed to dynamic scale from 1 to 11 Mbps (recommend factory default setting). To set the values for the data rate, check

the box next to the listed data rate to enable this rate for operation.

PAGE 1
APPENDIX D RADIO CONFIGURATION 195Ep FREQUENCY OF OPERATION In a wireless Ethernet network all of the ESTeem Model 195Ep’s must be set to the same radio frequency of operation or channel. The frequency of operation is selectable when configuring the mode of operation of the 195Ep (reference Chapter 4). See Figure 1. Figure 1: RF Channel Selection RF COMMUNICATIONS DATA RATE The RF data rate of the Model 195Ep can be programmed for operation at 1, 2, 5.5, or 11 Mbps.
PAGE 2
APPENDIX D RADIO CONFIGURATION Figure 2: Advanced Data Rate Selection RF BASIC RATE The RF Basic Rate is the synchronization rate used to establish the initial connection between 802.11g and 802.11b communication devices in Mbps. After the initial connection has been establish the RF communication rate will be determined by the RF Communication Data Rate established above. Factory default is 1 through 11 Mbps shown in Figure 2 so that the unity will establish communication with the older (slower) 802.