Manual

APPENDIX C

INTERFACE PORTS

Revised: 14 Jun 06 APX C-1 EST P/N AA107G

ETHERNET INTERFACE

The ESTeem Model 195Eg’s Ethernet Port is a Full and Half-Duplex Auto-negotiation interface supporting both 10 Mbps and 100

Mbps (10/100BaseT). The Ethernet port is compliant with IEEE 802.3af Power Over Ethernet (PoE) to provide both data and

power over the same CAT-5E grade Ethernet cable. The port is compatible with TIA/EIA-568B cable configuration.

CONFIGURING DHCP SERVER

The ESTeem 195Eg Ethernet port supports both client and server Dynamic Host Configuration Protocol (DHCP). Figure 1 shows

the DHCP host configuration screen that will be shown if DHCP server is selected in the setup screens. Enter the values that

match the DHCP configuration for your network.

Figure 1: DHCP Server Configuration

PAGE 1
APPENDIX C INTERFACE PORTS ETHERNET INTERFACE The ESTeem Model 195Eg’s Ethernet Port is a Full and Half-Duplex Auto-negotiation interface supporting both 10 Mbps and 100 Mbps (10/100BaseT). The Ethernet port is compliant with IEEE 802.3af Power Over Ethernet (PoE) to provide both data and power over the same CAT-5E grade Ethernet cable. The port is compatible with TIA/EIA-568B cable configuration.
PAGE 2
APPENDIX C INTERFACE PORTS RS-232C PROGRAMMING PORT CONFIGURATION RS-232 Programming Port The ESTeem Model 195Eg has a proprietary RS-232C interface in a RJ-45 connector on the front panel. To interface the 195Eg to the serial port on the computer, you need ESTeem cable AA0621 that combines a standard Ethernet patch cable to a 9-pin Female adapter. The serial port on the ESTeem Model 192E can be used to access the configuration menu in the ESTeem for system and network configuration.