User's Manual

12/1/03

Electronic Solutions, Inc.

11811 Upham St. Unit #2, Broomfield, CO 80020-2710

voice: 303-469-9322 fax: 303-469-5129 www.elec-solutions.com

Electronic Solutions, Inc.

T24A-Pdual433 with RR24 connected to RP24/RP60

Operation & Installation Manual

December 15, 2003

Specifications:

T24A-Pdual433 Transmitter

Power Supply Voltage 3V (2 AAA batteries)

Frequency 433.92 MHz

RR24 Receiver

Power Supply Voltage 5V (provided via RP24 or RP60)

PAGE 1
Electronic Solutions, Inc. T24A-Pdual433 with RR24 connected to RP24/RP60 Operation & Installation Manual December 15, 2003 Specifications: T24A-Pdual433 Transmitter Power Supply Voltage 3V (2 AAA batteries) Frequency 433.92 MHz RR24 Receiver Power Supply Voltage 5V (provided via RP24 or RP60) 12/1/03 Electronic Solutions, Inc. 11811 Upham St. Unit #2, Broomfield, CO 80020-2710 voice: 303-469-9322 fax: 303-469-5129 www.elec-solutions.
PAGE 2
RR24 Installation Guide Connect the RR24 Radio Receiver to the RP24/RP60 as shown The RR24 unit must connect to an Eye Jack on a RP24/RP60 or splitter. If the eye connects to a splitter, then the Main jack next to it must connect to the Eye Jack on an RP24/RP60. For best reception, the RR24 should be mounted with the antenna pointing up, and it should not be placed on or near a metal surface. The RR24 unit can learn up to 5 different transmitters to work with.
PAGE 3
Release the button, the red LED will come on, and the unit is ready to learn the 1st transmitter. If you press and release the learn button and the LED does not come on, the list is “full” and no more transmitters can be learned. Note that in the learn mode (button is pressed or the LED is on), the receiver is not passing commands to the RP24/RP60 system. Once the transmitter is learned, and if the STOP button is still held, the stop command will be sent to the system.