User Manual

August 2012, rev 1 © 2012 Electronic Solutions, Inc. Page 1 of 2
ESI RF RQ Transceiver
Install Guide - DRAFT
Electronic Solutions, Inc.
1355 Horizon Avenue
Lafayette, CO 80026 U.S.A.
www.elec-solutions.com
Tel: [phone]
Introduction
The ESI RF RQ Transceiver allows RQ devices to be added to ESI RF networks. The ESI RF RQ Transceiver
connects to the QEYE modular jack of AUM, DUM, EOS V2 and Forest Drapery track (TCS) RQ devices
without adding an additional power supply. When the ESI RF RQ Transceiver is networked with a V2 SUITE
remote, the attached RQ device will work in the following modes just like an ESI RF v2 motor:
 Latch and Run fashion, the same as the initial production release of SUITE remote (v1).
 Tilt Mode, replicating as much as possible the Tilt modes implemented in the RF Switch Interface.
These two methods of operation will be implemented as separate sub-modes of operation of the remote while
in User mode.
The ESI RF RQ Transceiver is considered a V2 ESI RF device, meaning it can respond appropriately to
SUITE V2 tilt commands and it can assign unique network groups to a SUITE V2 remote.
NOTE: a SUITE v2 remote cannot be used to set upper and lower limits for RQ devices connected to an ESI
RF RQ Transceiver. The upper and lower limits of all RQ devices must be set prior to connecting the ESI RF
RQ Transceiver. The RQ devices must also be calibrated before connecting the ESI RF RQ Transceiver --
ONLY if you want to set a PRESET.
COMMANDS
Join a Network: Plug into QEYE port, goes into Network Search (NOTE: only if at factory default with
no network information).
Triple button press: A “reset” to defaults. Clears network information and enters into Network Search
Mode.
Single button press: “Identifies” the dongle (for the Link Mode functions used on a remote).
Installation Steps
1. Set up and configure (limits and scenes) an ESI RF network of motor(s) and SUITE remote(s).
2. Join the ESI RF RQ Transceiver to the ESI RF network — plug into QEYE port on RQ device.
3. Test shade movement using buttons on the SUITE remote.
Parts List
Included:
 ESI RF RQ Transceiver.
 ESI RF Antenna (2.4 GHz) - onboard.
Usage:
 Interior use only.
Top view