User's Manual

Compatible with other Z-wave™ enabled devices.•
Mechanical motor limits must be set before performing the sequences below.•
If the Motor LED is red, the unit has not been calibrated and will not respond correctly.•
Verify OPEN button opens shade and CLOSE botton closes shade. If directions are •
swapped, see “Toggle Direction” below.
Calibration Procedure
Simultaneously press and hold both 1.
OPEN and CLOSE for at least 10
seconds until Motor LED turns solid
green.
Release both OPEN and CLOSE.2.
Within 10 seconds press and release 3.
CLOSE to start the calibration
sequence. (Press and release OPEN
instead to “Toggle Direction” and
start the calibration sequence.)
The calibration sequence will run the
motor from one limit to the other and
end with the shade closed, motor off,
and Motor LED off.
Unit is ready for use.•
Optional Z-Wave Include/Exclude
For “Include”, place the primary controller into the INCLUDE mode and do a quick press
of the LEARN button (Z-Wave LED will fl ash green). For “Exclusion”, place the primary
controller into the EXCLUDE mode and do a quick press of the LEARN button (Z-Wave LED
will fl ash green).
Electronic Solutions, Inc.
1355 Horizon Avenue
Lafayette, CO 80026
VOX +1 303.469.9322
FAX [phone]
Ratings
230VAC Unit: 230VAC 5A 1/2HP
115VAC Unit: 115VAC 8A 1/3HP
Mechanical
L: 5.25” W: 3.14” H: 2.0”
L: 133.4mm W:79.8mm H: 50.8mm
ABMHZ v1+1— Quick Setup
Version 1 11 June 2007
www.elec-solutions.com
Electronic
Solutions, Inc.
© 2007, Electronic Solutions, Inc.