User's Manual

April 27, 2005

Electronic Solutions, Inc.

11811 Upham St. Unit #2, Broomfield, CO 80020-2710

voice: 303-469-9322 fax: 303-469-5129 www.elec-solutions.com

Electronic Solutions, Inc.

93.640.5405 Transmitter with RR24 connected to RP24

Operation & Installation Manual

April 27, 2005

Specifications:

93.640.5405 Transmitter

Power Supply Voltage 3V (2 AAA batteries)

Frequency 433.92 MHz

RR24 Receiver

Power Supply Voltage 5V (provided via RP24)

PAGE 1
Electronic Solutions, Inc. 93.640.5405 Transmitter with RR24 connected to RP24 Operation & Installation Manual April 27, 2005 Specifications: 93.640.5405 Transmitter Power Supply Voltage 3V (2 AAA batteries) Frequency 433.92 MHz RR24 Receiver Power Supply Voltage 5V (provided via RP24) April 27, 2005 Electronic Solutions, Inc. 11811 Upham St. Unit #2, Broomfield, CO 80020-2710 voice: 303-469-9322 fax: 303-469-5129 www.elec-solutions.
PAGE 2
RR24 Installation Guide Connect the RR24 Radio Receiver to the RP24 as shown The RR24 unit must connect to an Eye Jack on a RP24 or splitter. If the eye connects to a splitter, then the Main jack next to it must connect to the Eye Jack on an RP24. For best reception, the RR24 should be mounted with the antenna pointing up, and it should not be placed on or near a metal surface. The RR24 unit can learn up to 5 different transmitters to work with.
PAGE 3
If you press and release the learn button and the LED does not come on, the list is “full” and no more transmitters can be learned. Note that in the learn mode (button is pressed or the LED is on), the receiver is not passing commands to the RP24 system. Once the transmitter is learned, and if the STOP button is still held, the stop command will be sent to the system.