user manual Washing Machine WAGLES 7000
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information Product description Control panel Personalization First use Daily use Helpful hints and tips Washing programmes 2 4 5 6 7 7 11 12 Care and cleaning What to do if… Technical data Consumption values Installation Electrical connection Environment concerns 16 19 22 23 23 27 27 Subject to change without notice SAFETY INFORMATION Important! Read carefully & keep for future reference.
electrolux 3 • When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre. • All packing and transit bolts must be removed before use. Serious damage can occur to the product and to property if this is not adhered to. See relevant section in the user manual. • After having installed the appliance, check that it is not standing on the inlet and drain hose and the worktop is not pressing the electrical supply cable against the wall.
electrolux button counterclockwise until the groove is vertical. PRODUCT DESCRIPTION Your new appliance meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. Its new washing system allows total use of detergent and reduces water consumption so saving energy. 2 1 3 4 5 6 1 Detergent dispenser drawer 2 Control panel 3 Door opening handle Detergent dispenser drawer Compartment for detergent used for prewash.
electrolux 5 CONTROL PANEL Below is a picture of the control panel. It shows the programme selector dial as well as the buttons and the display. 1 2 1 Programme selector dial 2 SPIN reduction button (U/Min. - Essorage) 3 PREWASH button (Vorwäsche - Prélavage) 4 STAIN button (Flecken - Taches) 5 SENSITIVE button (Sensitiv — Peaux sensibles) These are presented by relevant numbers on the following pages.
electrolux • End of programme: when the prois gramme has finished a blinking zero displayed, the symbol 7.5 (Door locked) disappears on the display, the pilot light of button 8 goes out and the door can be opened. • Incorrect option selection: if an option which is not compatible with the set wash programme is selected, the message Err is displayed for a few seconds and the yellow pilot light of button 8 light starts blinking.
electrolux 7 To enable or disable this option press simultaneously for about 6 seconds buttons 4 and 5 until the symbol 7.1 appears or disappears on or from the display. FIRST USE • Ensure that the electrical and water connections comply with the installation instructions. • Remove the polystyrene block and any material from the drum. • Pour 2 litres of water into the main of the deterwash compartment gent drawer in order to activate the ECO valve.
electrolux Select the desired TEMPERATURE (Button 2) When selecting a programme, the appliance automatically proposes the default temperature provided for that programme. Press this button repeatedly to increase or decrease the temperature, if you want your laundry to be washed at a temperature different from the one proposed by the washing machine. By selecting position Cold the machine will wash with cold water. To be used for extremely delicate items, such as curtains. Close the drawer gently.
electrolux 9 If an incorrect option is selected, the in yellow pilot light of the button 8 blinks for 3 times and the Err message appears on the display for some seconds. For the compatibility among the washing programmes and the options see chapter «Washing Programmes». Select the PREWASH option (Button 3) Select this option if you wish your laundry to be prewashed at 30°C before the main wash.
electrolux • Set the washing machine to PAUSE by pressing the button 8; • Press button 9 once until the symbol ’ is displayed; • Press the button 8 again to start the programme. Important! • The selected delay can be changed only after selecting the washing programme again. • The door will be locked throughout the delay time. If you need to open the door, you must first set the washing machine to PAUSE by pressing the button 8. After you have closed the door, press the button 8 again.
electrolux 11 7.5 goes off and the door can be opened. Turn the programme selector dial to to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. Stand by : once the programme has finished after a few minutes the energy saving system will be enabled. The brightness of the display is reduced.
electrolux • powder detergents for all types of fabric • powder detergents for delicate fabrics (60°C max) and woollens • liquid detergents, preferably for low temperature wash programmes (60°C max) for all types of fabric, or special for woollens only. The detergent and any additives must be placed in the appropriate compartments of the dispenser drawer before starting the wash programme. If using liquid detergents, a programme without prewash must be selected.
electrolux 13 Programme Maximum and Minimum Temperature Cycle Description - Maximum Spin Speed Maximum Fabrics Load - Type of Laundry Options 40 - 60 MIX 40° Main wash - Rinses - Long spin Maximum spin speed at 1400 rpm Max. load 7 kg White and coloured cotton This programme can be used for laundry, which should be washed at 40°C or 60°C separately. The maximum load capacity can be put into the drum in order to save energy and water.
electrolux Programme Maximum and Minimum Temperature Cycle Description - Maximum Spin Speed Maximum Fabrics Load - Type of Laundry Options DELICATES Feinwäsche/Délicats 40°- 30° Main wash - Rinses - Short spin Maximum spin speed at 1200 rpm Max. load 3,5 kg- Reduced load 2 kg1) Delicate fabrics: acrylics, viscose, polyester. SPIN (U/Min.
electrolux 15 Programme Maximum and Minimum Temperature Cycle Description - Maximum Spin Speed Maximum Fabrics Load - Type of Laundry SPIN Schleudern/Essorage Drain and long spin Maximum spin speed at 1400 rpm Max. load 7 kg Separate spin for hand washed cotton garments and after programmes with the Rinse Hold option selected. Before selecting this programme the selector dial Options SPIN (U/Min. - Essorage) .
electrolux Programme Maximum and Minimum Temperature Cycle Description - Maximum Spin Speed Maximum Fabrics Load - Type of Laundry Options Detergent Compartment /OFF Aus/Arrêt For cancelling the programme which is running or to switch the machine off . 1) If you select the Super Quick option by pressing button 6, we recommend that you reduce the maximum load as indicated. Full loading is possible however with somewhat reduced cleaning results.
electrolux 17 Washing drum Rust deposits in the drum may occur due to rusting foreign bodies in the washing or tap water containing iron. 2. If necessary wait until the water has cooled down. 3. Open the pump door. Important! Do not clean the drum with acidic descaling agents, scouring agents containing chlorine or iron or steel wool. 1. Remove any rust deposits on the drum with a cleaning agent for stainless steel. 2. Run a washing cycle without any washing to clean off any cleaning agent residues.
electrolux 8. Remove foreign bodies and fluff from the filter seat and from the pump impeller. blinks yellow or the display (if available) shows the relevant alarm (see chapter "What to do if..." for more details), check if the water inlet filters are blocked . To clean the water inlet filters: 1. Turn off the water tap. 2. Unscrew the hose from the tap. 3. Clean the filter in the hose with a stiff brush. 9. Check carefully whether the pump impeller rotates (it rotates jerkily).
electrolux 19 7. Screw the hose back to the machine and make sure the connection is tight. 8. Turn on the water tap. Emergency emptying out If the water is not discharged, proceed as follows to empty out the machine: 1. pull out the plug from the power socket; 2. close the water tap; 3. if necessary, wait until the water has cooled down; 4. open the pump door; 5. place a bowl on the floor and place the end of the emergency emptying hose into the bowl. Remove its cap.
electrolux Problem Possible cause/Solution The washing machine does not start: The door has not been closed. • Close the door firmly. The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. • Replace the fuse. The selector dial is not correctly positioned and the button 8 has not been pressed.
electrolux 21 Problem Possible cause/Solution There is water on the floor: Too much detergent or unsuitable detergent (creates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. • Check the water inlet hose connection. The drain or the inlet hose is damaged. • Replace it with a new one.
electrolux Problem Possible cause/Solution Spinning starts late or the machine does not spin: The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume. If, after some minutes, the laundry is still not evenly distributed in the drum, the machine will not spin.
electrolux 23 CONSUMPTION VALUES Programme Energy consumption (KWh) Water consumption (litres) White Cottons 95° 2.15 65 Cottons 60° 1.40 62 Cotton Energy Saving Programme 60° Energiesparen/Economique 1.05 49 1) Cottons 40° 0.75 62 Synthetics 40° 0.60 53 Delicates 40° 0.60 63 Wool/ Handwash 30° 0.25 57 Programme duration (Minutes) For the duration of the programmes, please refer to the display on the control panel.
electrolux 3. Unscrew the three bolts with the key supplied with the appliance. 4. Slide out the relevant plastic spacers. Positioning and levelling Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Before placing it on small tiles, apply a rubber coating. Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine.
electrolux 25 1. Open the porthole and extract the inlet hose. 2. Connect the hose with the angled connection to the machine. Caution! Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap. 3. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. The inlet hose must not be lengthened.
electrolux The end of the drain hose can be positioned in three ways: 1. Directly into a drain pipe. Attach the hook to drain hose and hang it in the drain pipe. Make sure that the drain hose doesn't fall down.The end of the drain hose must always be ventilated, i.e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose. 3. You can connect the drain hose to a siphon. The drain hose must be above the siphon. Fix the drain hose to the siphon with a clamp.
electrolux 27 ELECTRICAL CONNECTION Information on the electrical connection is given on the rating plate on the inner edge of the appliance door. Check that your domestic electrical installation can take the maximum load required, also taking into account any other appliances in use. Connect the machine to an earthed socket. injury through failure to comply with the above safety precaution. The power supply cable must be easily accessible after installing the machine.
www.electrolux.