MT21 IO T A RM N NFO I T TA N se R O ence r P u e f e M e r I efo re r b u t d u a f Re n for i a t e &r For all customer enquiries or for replacement parts, contact:- ☎ 01325 300303 www.flymo.com eop.customer.services@electrolux.co.
1 Carton Contents Mini Trim/MT21/ Mini Trim Auto Mini Trim Auto + Switch Lever Switch Lever Steady Handle Upper Shaft Upper Shaft Electric Cable with moulded on plug Electric Cable with moulded on plug Lower Shaft Lower Shaft Guard Instruction Manual Guard Instruction Manual IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new product.
2 4. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one. 5. Your extension cable must be uncoiled, coiled cables can overheat and reduce the efficiency of your trimmer. 6. Keep the cable clear of the cutting area and obstacles at all times. 7. Do not pull cable around sharp objects. 8.
3 Assembly Instructions A 1 Shaft Assembly (A) 1. Locate the lower shaft (A1) into the upper shaft (A2). 2. Grasp firmly and hold steady the lower shaft. Locate the upper shaft and snap together firmly. • The unit is correctly assembled when the gap between the upper and lower shaft has been closed. 2 1 B Mini Trim/MT21 1 Mini Trim Auto/ Auto + 2 2 C D 2 1 Safety Guard Assembly (B) & (C) 1. Locate the safety guard (B1) over the cutting head (B2).
4 Manual Line Feed System To 1. 2. 3. feed the nylon line Press and hold the two latches (H). Gently pull the line until it reaches the line cutter. Release the two latches. Check that the spool is locked in position. 4. If too much line has been fed out, press the two latches and turn the spool anti-clockwise until the line is at the desired length. H To remove spool 1. Press and hold the two latches. 2. Pull spool out of spoolholder (J). When refitting the spool 1.
5 Automatic Line Feed System M Line cutter N Manual line feed button P Cap Spool Cap release latch Spoolholder Eyelet Q Cut out area of spool Eyelet Cleat R How the automatic line feed works (M) 1. When initially switching on the trimmer, a small length of line is fed out. 2. A ‘clattering’ noise will be heard when the nylon line hits the line cutter. DO NOT BE ALARMED this is quite normal.
6 Fault Finding Chart (Automatic Line Feed only) WARNING Disconnect from the mains electricity supply before attempting any maintenance or adjustment. FAULT LINE NOT FEEDING OR LINE TOO SHORT OR TRIMMER VIBRATES CONTINUOUS CLATTERING NOISE LINE SNAPS CONTINUOUSLY CHECK ACTION Is the automatic line feed working? No Manually feed out line. Is the line fed out and visible? Has line been removed from cleat? No Remove cap and spool, free line and re-fit spool and cap.
Guarantee & Guarantee Policy If any part is found to be defective due to faulty manufacture within the guarantee period, Electrolux Outdoor Products, through its Authorised Service Repairers will effect the repair or replacement to the customer free of charge providing: (a) The fault is reported directly to the Authorised Repairer. (b) Proof of purchase is provided. (c) The fault is not caused by misuse, neglect or faulty adjustment by the user. (d) The failure has not occurred through fair wear and tear.