TIO RMA N NFO I T TA N se R O ence r P u e f e M e r I efo re r b u t d u a f Re n for i a t e &r For all customer enquiries or for replacement parts, contact:- ☎ 01325 300303 www.flymo.com eop.customer.services@electrolux.co.
Carton Contents Switch Lever Steady Handle Upper Shaft Electric Cable with moulded on plug Lower Shaft Instruction Manual Guard Wheel IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
4. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one. 5. Your extension cable must be uncoiled, coiled cables can overheat and reduce the efficiency of your trimmer. 6. Keep the cable clear of the cutting area and obstacles at all times. 7. Do not pull cable around sharp objects. 8.
Assembly Instructions A 1 Shaft Assembly (A) 1. Locate the lower shaft (A1) into the upper shaft (A2). 2. Grasp firmly and hold steady the lower shaft. Locate the upper shaft and snap together firmly. • The unit is correctly assembled when the gap between the upper and lower shaft has been closed. 2 2 1 B C Safety Guard Assembly (B) & (C) 1. Locate the safety guard (B1) over the cutting head (B2). Ensure the nylon line is fed through the hole in the safety guard as illustrated in fig B. 2.
How to trim and edge J • WARNING • The use of eye protection is recommended. Do not lean over the trimmer whilst trimming or edging, objects may be thrown by the cutting line. Do not allow cutting head to rest on the ground. Do not overload your trimmer. Overloading can be avoided by making sure the motor speed does not drop unduly. DISCONNECT FROM THE MAINS ELECTRICITY SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE OR ADJUSTMENT. • BEFORE USE Make sure that both lines are fed out.
Cutting Head Q Cap Cap release latch Spool Spoolholder Eyelet R Cut out area of spool Eyelet S1 S Cleat To remove spool cap 1. Press and hold in the two cap release latches. (Q). 2. Pull cap away from the spoolholder. (Q). When refitting the spool cap 1. Keep all areas of the cap and spoolholder clean. Failure to do so may prevent the cap being securely located in the spoolholder. 2. Replace the cap, pressing firmly DOWN towards the spoolholder to ensure cap is fully located. 3.
Maintenance V 4. Remove the wheel by pressing one of the buttons. Clean the wheel and groove on trimmer head with a soft brush (V & W). 5. Attach wheel as described in Wheel Assembly. 6. Inspect the trimmer carefully, especially the parts of the cutting head. 7. If your trimmer is damaged in any way contact your local Electrolux Outdoor Products approved service centre. • Never use a damaged trimmer. 8. Wind cable carefully to avoid kinking. 9. Store in a cool, dry place and out of reach of children.
Service Recommendations • • Your product is uniquely identified by a silver and black product rating label. We strongly recommend that your product is serviced at least every twelve months, more often in a professional application.