user manual Washing Machine EWS 105410 A EWS 125410 A
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.
electrolux 3 • Do not install and connect a damaged appliance. • Make sure to remove all packaging and transport bolts. • Make sure that the mains plug is disconnected from the mains socket during installation. • Only a qualified person must do the electrical installation, the plumbing and the installation of the appliance. This to prevent the risks of structural damage or injury. • Do not install or use the appliance where the temperature is less than 0 °C.
electrolux TECHNICAL INFORMATION Dimensions Width / Height / Depth Electrical connection: Voltage Overall power Fuse Frequency 600 / 850 / 480 mm 220-240 V 2100 W 10 A 50 Hz IPX4 Level of protection against ingress of solid particles and moisture ensured by the protective cover, except where the low voltage equipment has no protection against moisture Water supply pressure Minimum 0,5 bar (0,05 MPa) Maximum 10 bar (1 MPa) Water supply 1) Cold water Maximum load Cotton Spin speed Maximum 5
electrolux 5 ACCESSORIES 1 2 Large plastic caps To close the holes on the rear side of the cabinet after the removal of the transit bolts. 3 Plastic hose guide To connect the drain hose on the edge of a sink. 4 Small plastic caps To attach the protection cover to the bottom of the appliance. 2 4 3 1 Inlet hose To connect the appliance to the cold water tap.
electrolux DISPLAY 2 A B C D The display shows: A • The delay start When you press the delay start button, the display shows the delay start time. B • The default spin speed of the programme. • 'No Spin' (00). C • The display symbols. The symbols appear on the display when the related function is set. D • The programme time • Alarm codes If the appliance has a malfunction, the display shows alarm codes. Refer to 'Troubleshooting' chapter. • End It comes on when the programme is completed.
electrolux 7 PROGRAMMES Programme Temperature Type of load and soil Weight of load Programme phases Bawełniane 90 – 75 °C White cotton with heavy soil. This programmes add also the phase of hygiene to the laundry. max. 5 kg Wash Rinses Spin phase at the maximum speed + Bawełniane Eco1) 60 °C White and fast coloured cotton with normal soil. max. 5 kg Wash Rinses Spin phase at the maximum speed + Bawełniane Eco1) 40 °C White and coloured cotton with normal or light soil. max.
electrolux Programme Temperature Type of load and soil Weight of load Programme phases Wełniane 40 °C – Cold Machine washable wool. Hand washable wool and delicate fabrics with «hand washing» care symbol. max. 1 kg Wash Rinses Spin phase at 800 rpm — Handwash - Silk 30 °C Hand washable delicate fabrics with «hand washing» care symbol. max. 1 kg Wash Rinses Spin phase at 800 rpm 35 °C Quick wash of cotton, synthetic, delicate or mixed fabric items with light level of soil or worn once. max. 2.
electrolux 9 energy and water consumption for washing that type of cotton laundry. They agree with EN60456. The actual water temperature may differ from the declared cycle temperature. HINTS AND TIPS THE LAUNDRY LOAD • Divide the laundry in: white, coloured, synthetics, delicates and wool. • Obey the washing instructions that are on the laundry care labels. • Do not wash together white and coloured items. • Some coloured items can discolour with the first wash.
electrolux Level Type Water hardness °dH °T.H. mmol/l Clarke 3 hard 15-21 26-37 2.6-3.7 17-25 4 very hard > 21 > 37 >3.7 >25 BEFORE FIRST USE 1. To activate the drain system, put 2 litre of water in the main wash compartment of the detergent dispenser. 2. Put a small quantity of detergent in the main wash compartment of the detergent dispenser. Set and start a programme for cotton at the highest temperature without laundry. This removes all possible dirt from the drum and the tub.
electrolux 11 2. Pull out the detergent divider from its position (A). 4. Press the Start button to start the programme until the button indicator is on. CANCEL A PROGRAMME 1. Turn the programme knob to to cancel the programme and to deactivate the appliance. 2. Turn the programme knob again to activate the appliance. Now, you can set a new washing programme. The appliance does not drain the water. A 3. Put it into the special guides in the middle of the compartment for the washing phase.
electrolux If the temperature and level of the water in the drum are too high, you cannot open the door. To open the appliance door: • Do the steps 1 and 2 again. • Wait for some minutes. • Make sure that no water is in the drum. AT THE END OF THE PROGRAMME • The appliance stops automatically. • The display shows the End symbols. • Turn the programme knob to to deactivate the appliance. • Remove the laundry from the appliance. Make sure that the drum is empty.
electrolux 13 4. Clean the dispenser recess with a brush. DETERGENT DISPENSER To clean the dispenser: 1. Press the lever and pull the dispenser out. 5. Put back the dispenser in the recess. DRAIN PUMP Regularly examine the drain pump and make sure that it is clean. Clean the pump if: • The appliance does not drain the water. • The drum cannot turn. • The appliance makes an unusual noise because of the blockage of the drain pump. 2. Remove the top part of the liquid additive compartment. Warning! 1.
electrolux 3. Unscrew the filter to let the water flow out. 9. Make sure that you tighten correctly the filter to prevent leakages. 1 2 4. When the container is full of water, screw the filter again and empty the container. Do steps 3 and 4 again and again until no more water flows out from the drain pump. 5. Unscrew the filter and remove it. 1 10. Close the drain pump door. CLEAN THE INLET VALVE FILTER It could be necessary to clean the filter when: • The appliance does not fill with water.
electrolux 15 4. Install again the inlet hose. Make sure that the couplings are tight to prevent leakages. 5. Open the water tap. EMERGENCY DRAIN Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (5) of 'To clean the drain pump'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2.
electrolux Problem The appliance does not fill with water. The appliance does not drain the water. The spin phase does not operate. There is water on the floor. You cannot open the appliance door. The appliance makes an unusual noise. Possible cause Possible solution The programme knob is not in the correct position. Turn the programme knob in the correct position. The delay start is set. It is available only for models with the Delay start.
electrolux 17 Problem Possible cause Possible solution The appliance fills with water and drain immediately. The end of the drain hose is too low. Make sure that the drain hose is in the correct position. Refer to 'Installation'. The washing results are not satisfactory. The detergent you used was not sufficient or correct. Increase the detergent quantity or use a different one. You did not remove the stubborn stains before you wash the laundry. Use special products to remove the stubborn stains.
electrolux 3. Remove the internal film. 6. Remove the polystyrene protection from the bottom. 1 4. Open the door and remove all the items from the drum. 2 7. Install the plastic cover (A), removed from the top of the packaging, to the bottom of the appliance. Remove the adhesive strip and close the bottom of the appliance. Attach permanently the plastic cover to the bottom of the appliance with the small plastic caps that you can find in the user manual bag. 5.
electrolux 19 10. Put the plastic caps in the holes. You can find these caps in the user manual bag. Caution! Do not put cardboard, wood or equivalent materials below the appliance feet to adjust the level. Warning! Remove all the packaging and the transit bolts before you install the appliance. THE INLET HOSE • Connect the hose to the appliance. Loose the ring nut to set it in the correct position. We recommend that you keep the packaging and the transit bolts for when you move the appliance.
electrolux With the plastic hose guide. • Without the plastic hose guide. • To a sink spigot. Refer to the illustration. Put the drain hose in the spigot and tighten it with a clip. Make sure that the drain hose makes a loop to prevent that remaining particles go in the appliance from the sink. • On the edge of a sink. Make sure that the plastic guide cannot move when the appliance drains. Attach the guide to the water tap or the wall.
electrolux 21
electrolux
electrolux 23
www.electrolux.