MODEL: EWF073CM5WA EWF093CM5WA EWF123CR6WA EWF073CR6WA EWF093CR6WA EWF183CR6WA
CONTENTS Our design is based on the best efficiency and the lowest noise operation and it can keep the room comfortable. Please read this operating manual carefully before operating the unit and keep it for consultation.
Function Introduction Autumn Spring Room temp. Summer Winter Wind direction Window type room air conditioners can regulate the room temperature and dry the room. It is convenient for your work,study and life. It can be widely used in residence, shop, hotel, office, library and laboratory, and so on. Dehumidifying in rainy or humid season Cooling in summer Without reducing the room temp., air conditioner can dehumidify and make the room air dry and comfortable.
Operating Condition Please operate air conditioner in the correct conditions as following. COOL mode operation DRY mode operation Outdoor temperature should be in range of 18 to 43 , otherwise it is possible for air conditioner to breakdown. Room humidity should be lower than 90%. Otherwise, it is possible for air conditioner to dew at air conditioner surface and even drop water after running for so much time. But this is normal.
Installation Installation precaution: Window type conditioner is so valuable and the improper installation of it will cause a lot of damage! Please associate the professional technician to install the unit and don’t install it by yourself. Otherwise, we are not responsible for the damage like this.
Installation procedure: Horizontal line 1) Remove the sticker from the front panel. 2) Put the unit into the installation hole. When installing the unit, it should be slanted down to the back to avoid the enlargement of noise or vibration. (Slant between 6-10mm.) (Shown at right figure.) The installation place should be strong enough to avoid the enlargement of noise or vibration. 3) Fill up sews in the cabinet with sponge or foam.
Drain water for one style: To get the maximum cooling efficiency,the air conditioner is designed to splash the condensate on the condenser coil. If the splashing sound annoys you, you can provide an outside drain by using the following procedure, which may however cause a small loss of performance. 1.There is a drainage outlet at the back of the unit. 2.Remove cover from the drainage outlet , and then connect drainage joint to it with screw. 3.Connect the drain hose to the outlet.
Notes for installation Remove Before removing air conditioner to the other place, you should contact the seller firstly. Then it must be done under the direction of the professional technician. In addition, the charge of this must be paid. Noise Install in a location where is firm enough to avoid the enlargement of noise and vibration. Don’t put anything in front of the outlet of outdoor unit to avoid increasing noise. Be sure that hot air or noise will not inconvenience neighbors.
Parts identification Mechanical Model Panel outlook picture, just for reference, please take the real unit as standard. Cabinet Air inlet louver Front grille Front intake grille Control panel Air filter (behind the front intake grille) Power cord Remote Control Model Panel outlook picture, just for reference, please take the real unit as standard.
Main switch operation procedure (Applicable to Mechanical Models ONLY) 1.Main Control Knob Set to Low Cool,Med Cool or High Cool as desired (FAN setting operates the fan only.) CAUTION:If the main control knob is turned off changed to a fan setting from a cooling operation setting, WAIT at teast 3 minutes before resetting to cooling operation. 2.Thermostat control Knob Set the thermostat control knob to your desired setting(Usually 6-7 is recommended).
Operation of wireless remote control (Applicable to Remote Control Models ONLY) Name and function of wireless remote control Note: Besure that there are no obstructions between receiver and remote controoler; Don't drop or throw the remote control; Don't let any liquid in the remote control and put the remote control directly under the sunlight or any place where is very hot. SLEEP Signal transmitter SLEEP button Press this button, Sleep On and Sleep Off can be selected.
Name and function of wireless remote control Note: This wireless remote control is universal, andit could be used for many units, some buttons of this control which are not available to this unit will not be described below. + Presetting temperature can be increased.
Name and function of wireless remote control Note: This wireless remote control is universal, and it could be used for many units, some buttons of this control which are not available to this unit will not be described below. TIMER ON TIMER ON BUTTON At unit off, press Timer On button, "HOUR ON" will blink and display, signal will be concealed, in the timer on setting. During 5 seconds blinking, the value can be adjusted by pressing + or - button, every press of this button, 0.
Guide for operation- general operation 1. After powered on, press ON/OFF button, the unit will start to run. (Note: When it is powered on the guide louver of main unit will close automatically.) 2. Press MODE button, select desired running mode. 3. Pressing +or - button, to set the desired temperature (It is unnecessary to set the temp. at AUTO mode.) 4. Pressing FAN button, set fan speed, can select AUTO FAN, LOW, MID and HIGH. 5. Pressing SWING button, to select the swing.
About switch between Fahrenheit and Centigrade Under status of unit off, press MODE and - buttons simultaneously to switch and . Changing batteries and notices 1. Slightly to press the place with , along the arrowhead direction to push the back cover of wireless remote control. (As show in figure) 2. Take out the old batteries. (As show in figure) 3. Insert two new AAA1.5V dry batteries, and pay attention to the polarity. (As show in figure) 4. Attach the back cover of wireless remote control.
Remote control panel Note: If wireless remote controller is lost, open the surface panel and operate manually. 1 2 POWER BUTTON Operation starts when pressing this button, and stops when pressing this button again. SWING BUTTON Activate the automatic air swing function. 3 FAN SPEED BUTTON Select the fan speed HIGH, MID, LOW and AUTO in sequence. 4 TEMP/TIMER BUTTON Press the keypad to increase the set (operating) temperature of the unit.
Operation Tips Operation for comfort and economy Do not overcool the room temperature. This is not good for health and wastes electricity. Keep blind or curtains closed. Do not let sunshine enter the room directly when the air con- Keep the room temp. uniform. Adjust the vertical and horizontal airflow direction to ensure a dition is in operation. uniform temperature in the room. Air can’t be discharged to the direction of air-in. Make sure that the doors and windows are tightly closed.
Caution Operations for safety and health 1) The plug must be accessible after the appliance is positioned. 2) Do not use this appliance in the laundry. 3) If the power cord is damaged, it must be replaced by the manufacture or its service agent in void of hazard. Do not pull out the power cord. Damage to the cord may result in serious electric shocks. Select the most appropriate temperature. Pay attention to adjust the temperature to suit the conditions.
Care and maintenance Always turn off the air conditioner and main power supply before cleaning to ensure safety. Cleaning unit 1. Cut power off before cleaning. Air filter The air filter behind the intake grille should be washed at least once every two weeks or as often as it needs cleaning. Plug out only after air conditioner stops at all. How to clean the air filter: 1. To remove the air intake grille, grasp the tab on the filter and pull to take out. 2. Use soft cloth when cleaning cabinet.
Trouble shooting guide Please check the following items before asking for repair,it saves your time and money. Fault phenomenon Air conditioner dose not operate at all. Trouble-shooting * Is there a power failure? * Is the plug out? * Is power fuse or switch off ? * Whether the voltage is too high or too low? * Is air inlet or outlet locking? * Is there any other heat/cool source in room? Cool or heat efficiency is * Are air filters dirty very much? not good.
Immediately stop all operations and plug out, please contact your dealer in the following situations. *Operation starts or stops abnormally; *Power fuse or switch often breaks; *Carelessly splash water or something into air conditioner; *Electrical lines are much hot or lines cover breaks; *Other strange situations. After service If your air conditioner has the questions of quality or anything else, please contact the service center of Electrolux.