User manual

7ENGLISH
5.1 Switching on
To switch on the appliance follow these
steps:
1. Connect the mains plug to the power
socket.
2. Press the ON/OFF button if the dis-
playiso󺦲.
3. The display shows the set default
temperature (5°C).
Toselectadi󺦲erentsettemperature
refer to “temperature regulation”.
5.2 Switchingo󺦲
Toswitcho󺦲theappliancefollowthese
steps:
1. Press the ON/OFF button for 3 sec-
onds.
2. Thedisplayswitcheso󺦲.
3. To disconnect the appliance from the
power disconnect the mains plug from
the power socket.
5.3 Temperature regulation
The set temperature of the wine cellar
may be adjusted by pressing the
temperature regulators.
Each press once the
or button, the
temperature setting will increase or lower
1ºC, When the temperature setting reach
the upper limit 20ºC and lower limit 5ºC,
the temperature setting will not increase
or lower.
5.4 Light Button
When the door is opened,the LED light is
on,whenclosediso󺦲.Ifyouwanttokeep
the light on with the door closed, open the
door,pressthelightbuttontoturno󺦲the
light, then press the light button again to
turn onthe light.
If you want to restore the standard
conditions, press the light button to turn
o󺦲thelight.
LED Light is equipped with a
smoothshuto󺦲systemlasting3
sec onds.
5.5 Door open alarm
An acoustic alarm will sound if the door is
not completely close d after 5 minutes.
When the door is closed the alarm will
stop.
5.6 Temperature Alarm
• If the inner temperature is higher than
23°C,“HI” is shown in display panel,
and the buzzer rings for one hour
continuously.
• If the inner temperature is lower than
0°C, “LO” is shown in display panel
and blinks. The buzzer rings at the
same time.
5.7 Temperature Recollection
Function
In the event of a power interruption, the
wine cellar can remember the previous
temperature settings, and when power is
recovered, the temperature will go back
to the original.
6. DAILY USE
6.1 Cleaning
Before using the appliance for the
firsttime,washtheinteriorandall
internal accessories with lukewarm
water andsome neutral soap in order to
remove thetypical smell of a brand-new
product,then dry thoroughly.
Do not use detergents or abrasive
powders, as these will damage the
finish.