user manual Fridge ERES38810W ERES38810X
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.
electrolux 3 components of the refrigerant circuit become damaged. If the refrigerant circuit should become damaged: – avoid open flames and sources of ignition – thoroughly ventilate the room in which the appliance is situated • It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short-circuit, fire and/or electric shock.
electrolux Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger.
electrolux 5 Important! At start up the displayed temperature don’t correspond with the set temperature until stabilized (within 24 hours). Functions Menu By activating the key (D) the functions menu is operating. Each function could be confirmed by pressing button (E). If there is no confirmation after some seconds the display will go out from the menu and return in normal condition.
electrolux es. Confirm cancellation by pressing button (E). The Quick Chill bottle holder can be removed if not used. Door open alarm An acoustic alarm will sound if the door is left open for a few minutes. The door open alarm conditions are indicated by: • flashing icon • acoustic buzzer When normal conditions are restored (door closed), the alarm will stop. During the alarm phase, the buzzer can be switched off by pressing button (E).
electrolux 7 To activate the child lock function Press buttons 2 and 3 at the same time for about three seconds. Activation is indicated by the child lock indicator is lighting. Selecting and dispensing water Before dispensing water, select either carbonated water (2) or plain water (3). The actual choice is indicated by the lit button. Water selection can be changed while the water is running. Water is dispensed by pressing a glass or other container towards the flap (6).
electrolux Daily use Use of the fridge compartment The temperature of this compartment may be regulated between +2°C and +8°C. During normal functioning the indicator shows the temperature inside the fridge. A medium setting is generally the most suitable. The exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: • room temperature • how often the door is opened • the quantity of food stored • the location of the appliance.
electrolux 9 gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Important! Do not move the lower door shelf to ensure correct air circulation. Helpful hints and tips Hints for energy saving • Do not open the door frequently or leave it open longer than absolutely necessary.
electrolux temperature can be monitored. The measuring shall be performed under steady-stated conditions (without changing the load). Care and cleaning Caution! Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians.
electrolux 11 The replacement gas cylinder is obtained through your local dealer. Cleaning the water dispenser When necessary, clean the surfaces of the dispenser, using only a soft cloth and warm water. The dispenser drip tray can be cleaned with a lukewarm water and some neutral soap. Lime deposits on the dispenser surface can removed using vinegar or diluted acetic acid as cleaning agent. Wipe clean with a damp cloth. ing normal use.
electrolux Problem Possible cause Solution The spacers located between the Put them back in place again. back of the cabinet and the pipes come loose. Sound level is too high during dispensing of water. The transport supporting tie of Remove the tie. Refer to "Removthe water system pressure pump ing the transport support". has not been removed. The buzzer sounds. The Alarm light flashing. The door is not closed correctly. upper or lower square is shown in the temperature display.
electrolux 13 Problem Possible cause Solution The appliance has no power. There is no voltage in the mains socket. Connect a another electrical appliance to the mains socket. Check fuse. Contact a qualified electrician. Not enough carbon dioxide in the water. The carbon dioxide is running out. Refer to "Installation of the gas cylinder". Too much carbon dioxide in the water. Dilute with ordinary water. Refer to "Selecting and dispensing water". No carbon dioxide. The gas cylinder is empty.
electrolux Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact the Service Center. Technical data ERES38810W ERES38810X Dimension Height 1800 mm 1800 mm Width 595 mm 595 mm Depth 650 mm 650 mm The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label.
electrolux 15 mm . Ideally, however, the appliance should not be positioned below overhanging wall units. If the cabinet is placed in a corner and the side with the hinges facing the wall, the distance between the wall and the cabinet must be at least 150 mm to allow the door to open enough so that the equipment can be removed. The ventilation space can be: • directly above the appliance • behind and above the top cupboard. In this case, the space behind the top cupboard must be at least 50 mm deep.
electrolux 1. Move the shelf holders in the direction of the arrow (A). 2. Raise the shelf from the rear and push it forward until it is freed (B). 3. Remove the retainers (C). Rear spacers Install the spacers provided within the accessory bag as shown in the figure. When two appliances are placed beside each other, attach the adhesive spacers between the appliances. Connecting the water hose. Water supply should be provided with a tap and 3/4" male connector within 1,5 m from the appliance.
electrolux 17 Installation of the Taste Guard filter The Taste Guard filter is an active carbon filter which absorbs bad odours maintain the best flavour and aroma for all foodstuffs without risk of odour cross contamination. On delivery the carbon filter is in a plastic bag to preserve performance. 1. Open the air lever flap. Starting the water system for the first time. Ensure proper connection to the water supply, refer to "Connecting the water hose". 1. Open the tap on the water connection. 2.
electrolux supports the protruding parts of the adapter. 6. Remove cloth or towel and make sure that spilled water is wiped off. 7. Close the hatch and remount the interior. 8. Keep the bypass cartridge for future use. 9. Unlock the water dispenser. Refer to "Child lock functions". Select plain water and dispense about 2 litres of water. There may be some air to start with. 3. Then turn the lever upwards in one continuous movement. Installation of the gas cylinder 1.
electrolux 19 The water supply goes through the hinge to the water dispenser. Contact your dealer for more information. Environmental concerns The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment.
www.electrolux.