User manual

Clean the glass panel with water and soap.
Dry the glass panel carefully.
Installing the door and the glass panel
After cleaning, install the glass panel in op-
posite order.
Make sure that when you install the internal
panel with a decorative frame, the screen-
printing is on the outer side. Make sure that
the surface of the glass panel frame is not
rough when you touch it.
Make sure that you put the internal panel of
glass to the correct seats (refer to the pic-
ture).
Replacing the oven light bulb/cleaning
the glass cover
Warning! Be careful! There is the risk of
electrical shock!
1. Turn the glass cover anti-clockwise to re-
move it.
2. Clean the glass cover.
3. Replace the oven light bulb with applica-
ble 300°C heat-resistant oven light bulb.
New oven light bulb must have the same
parameters as your previous one.
4. Install the glass cover.
What to do if…
Warning! Refer to "Safety information"
chapter.
Problem Possible cause Remedy
The oven does not heat up The oven is not switched on Switch on the oven (refer to
chapter "Daily use").
The oven does not heat up The fuse in the fuse box is re-
leased
Control the fuse. If the fuse is re-
leased more than one time, refer
to a qualified electrician.
The oven lamp does not operate The oven lamp is defective Replace the oven lamp
Steam and condensation settle
on the food and in the oven cav-
ity
You left the dish in the oven for
too long
Do not leave the dishes in the
oven for longer than 15-20 mi-
nutes after the cooking process
ends
If you cannot find a solution to the problem
yourself, contact your dealer or the service
centre.
The necessary data for the service centre is
on the rating plate. The rating plate is on the
front frame of the oven cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
electrolux 11