I N F O OPERATING AND ASSEMBLY INSTRUCTIONS GLASS CERAMIC HOB EHH 800 X GB
DEAR CUSTOMER We congratulate you on choosing a ceramic hob of ELECTROLUX. Thus you chose quality, innovation and durability. These operating and assembly instructions will allow you to become acquainted with the appliance and to do everything within its possibilities.
CONTENT Please note in particular ......................................... 4 Unpacking and control ........................................... 5 Description of appliances ...................................... 5 Before the first use ................................................ 5 Technical data ....................................................... 6 Operating instructions ............................................ 6 Cooking equipment ................................................ 7 Maintenance ...
PLEASE NOTE IN PARTICULAR Before using the hob for the first time, read the operating and assembly instructions carefully. You protect yourself and avoid damage of your appliance. The appliance must be installed by a qualified electrician. Use the hob only upon its installation. This protects you from touching electric parts. Repairs of electric appliances must be undertaken by qualified electricians only. Improper repairs can cause serious harm and danger for the user.
UNPACKING AND CONTROL Please examine the appliance for any damage sustained during transportation! If the appliance is damaged please immediately inform the forwarding company before the appliance is connected. The packing material should be disposed properly.
TECHNICAL DATA Hob dimensions length width height 795 mm 515 mm ~43 mm Cutout dimensions length width 780 mm 500 mm Voltage 220-230 V ~ 50 Hz Total power 7.42 kW Rating plate Typ Instr. No. Mod. EHH 800 X Prod.No. 941 592 622 Ser.No. 7.42 kW 220-230 V ~ 50 Hz SWISS MADE OPERATING INSTRUCTIONS Cooking zones The cooking zones are clearly marked on the ceramic surface. Only the cooking zone which is switched on will be heated up. The remaining surface will not get hot.
OPERATING INSTRUCTIONS Residual heat indicator Each cooking zone is related to one indicator. The warning lamp lights up when the surface of the corresponding cooking zone reaches a temperature which could cause burning. This lamp remains lit after the heated-up area has been switched off as long as the residual heat of the corresponding cooking surface can cause burnings. The light will only extinguish when there is no more danger (temperature below 50°C).
MAINTENANCE The maintenance remains the same for glass and ceramic hobs. Never use aggressive detergents or scouring powder and sponges with abrasive surfaces. Cleaning after each use Slight, not burnt soiling has to be wiped off with a damp cloth without using detergents. The use of detergents may lead to discolouring. These heavy stains can not be wiped off easily by the first attempt and sometimes not even with a special detergent. Burnt soiling has to be removed with a scraper.
INSTALLATION 1 . Cut out worktop to prescribed measurements (fig.1) or templates (saw exactly along the scribing) and fasten the fixing springs in the cutout with the enclosed screws. Position the springs according to the enclosed template. The upper part of the ressort is the spacing stop. fig.1 2 . The working plate must be clean. Check seal for perfect fit and overall cover. Lower the ceramic hob into the cut-out. Press firmly on one side then on the opposite side to snap-in the unit (fig.2).
PROBLEM DETECTION AND REPAIR DEVICE Repairs on electrical appliances must be undertaken by qualified electricians only. Improper repairs can cause serious harm and danger for users. The appliance is only disconnected from the mains when the fuse is turned off or the mains connection is interrupted You are able to clear the following defects: When the cooking zone does not heat up after you switched it on? =>Make sure that the fuse is turned on.
11.