user manual Gas hob MY SG TH EHG30810
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS Safety information Installation Product description Operation Helpful hints and tips 2 4 7 8 9 Care and cleaning What to do if… Technical data Environment concerns 9 10 11 12 Subject to change without notice SAFETY INFORMATION Warning! These instructions are only valid in the countries whose symbols appear on this booklet's cover.
electrolux 3 • Use only the accessories supplied with appliance. • Be careful when you connect the appliance to the near sockets. Do not let electricity bonds touch the appliance or hot cookware. Do not let electricity bonds tangle. INSTALLATION • You must read these instructions. The manufacturer is not responsible for any injury to persons and pets or damage to property caused by failure to obey these requirements.
electrolux with applicable cable. Speak to your local Service Force Centre. • The appliance must have the electrical installation which lets you disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm. • If the fixing bracket is near to the terminal block, always make sure the connection cable does not come in contact with the edge of the bracket.
electrolux 5 – it shows no throttles; – it is not subject to traction or torsion; – it does not get in touch with cutting edges or corners; – it can be easily examined in order to check its condition. The control of preservation of the flexible pipe consists in checking that: – it does not show cracks, cuts, marks of burnings on the two ends and on its full length; – the material is not hardened, but shows its correct elasticity; – the fastening clamps are not rusted; – expired term is not due.
electrolux 4. With a thin screwdriver, adjust the bypass screw position. 1 1 The by-pass screw – If you change from town gas to liquid gas, fully tighten the by-pass screw in. – If you change from liquid gas to town gas, undo the by-pass screw approximately 1/2 of a turn. Warning! Make sure the flame does not go out when you quickly turn the knob from the maximum position to the minimum position. ELECTRICAL CONNECTION • Ground the appliance according to safety precautions.
electrolux 7 a) Removable panel b) Space for connections A Kitchen unit with oven The hob recess dimensions must obey the indication and the kitchen unit must be equipped with vents to let a continuous supply of air. The electrical connection of the hob and the oven must be installed separately for safety reasons and to let easy remove oven from the unit.
electrolux CONTROL KNOBS Symbol Symbol Description no gas supply / off position Description ignition position / maximum gas supply minimum gas supply OPERATION IGNITION OF THE BURNER Warning! Be very careful when you use open fire in kitchen environment. Manufacturer decline any responsibility in case misuse of the flame Always light the burner before you put cookware. To light the burner: 1. Turn the control knob counterclockwise ) and to the maximum position ( push it down. 2.
electrolux 9 HELPFUL HINTS AND TIPS ENERGY SAVINGS • If possible, always put the lids on the pans. • When the liquid starts to boil, turn down the flame to barely simmer the liquid. Warning! Use pots and pans with diameter applicable to the dimension of burner. Do not use cooking vessels on the hotplate that overlap its edges. Burner Diameters of cookware Ultra-Rapid 180 - 260 mm Do not simmer for a long time with cast iron pans and potstones.
electrolux 2. Clean the appliance with a damp cloth and some detergent. 3. At the end rub the appliance dry with a clean cloth. The stainless steel can become tarnished if it is too much heated. Refer to this you must not cook with potstones, earthenware pans or cast iron plates. Do not use aluminium foil to prevent damage the top during operation. these components well clean to prevent difficult lighting and check that the burner crown holes are not obstructed.
electrolux 11 If there is a fault, first try to find a solution to the problem yourself. If you cannot find a solution to the problem yourself, speak your dealer or the local Service Force Centre. If you operated the appliance incorrectly, or the installation was not carried out by a registered engineer, the visit from the customer service technician or 1 dealer may not take place free of charge, even during the warranty period.
electrolux Appliance class: By-pass diameters 3 Burner Ø By-pass in 1/100 mm Ultra-Rapid 56 Gas burners BURNER Ultra-Rapid NORMAL POWER REDUCED POWER NORMAL POWER kW kW inj. 1/100 mm m³/h inj. 1/100 mm G30 28–30 mbar g/h g/h 3.7 (Town gas) 4.0 (LPG) 1.4 312 0.
electrolux 13
electrolux
electrolux 15
www.electrolux.