Use & Care Manual Assembly Instructions Included 30" Stainless Steel Outdoor Grill with Electronic Ignition Welcome & Congratulations . . . . . . 1 General Safety Instructions . . . . . . . 2 Grill Features: GL30. . . . . . . . . . . . . 3 Grill Assembly Side Burner Assembly Built-In Instructions . . . . . . . . . . . 4-7 Gas Requirements Pre Operation Leak Testing . . . . . 8-9 Lighting the Gril. . . . . . . . . . . . . . . 10 Using the Grill Using the Rotisserie & Side Burners . . . . . . . . . . .
Welcome & Congratulations Congratulations on your purchase of a new grill! We at Electrolux are very proud of our product and we are completely committed to providing you with the best service possible. Your satisfaction is our #1 priority. Please read this Use & Care Manual very carefully. It contains valuable information on how to properly maintain your new grill. We know you’ll enjoy your new grill and thank you for choosing our product. We hope you consider us for future purchases.
General Safety Instructions 2
Grill Features: GL30 7 1 8 2 9 12 3 13 4 10 5 11 6 1. Roll top grill hood 8. Warming shelf 2. Grilling/Cooking surface 9. Infrared back burner 3. Side Shelf 10. Electronic igniter: main, rear infrared & side burner 4. Control knob: back infrared burner 11. Cart with door 5. Control knobs: main burners 12. Side Burner 6. Convection vents 13. Control knob: Side Burner 7. Hood Handle NOTE: Cart, side burner and side shelf are not included with the head only units.
Grill Assembly IMPORTANT: Remove all protective plastic film from stainless steel parts prior to assembly/use. This film is installed at the factory to prevent damage that could occur during shipment and handling. Shelf Hooks Fig. 1 SIDE SHELF ATTACHMENT 1. Attach the shelf to the left side of grill by inserting the shelf hooks into the slots on the side of the grill and pushing down on the shelf assembly until level with grill. (See Fig. 1) 2.
Side Burner Assembly SIDE BURNER PARTS ASSEMBLY 1. Attach the side shelf to the grill by inserting the shelf hooks into the slots on the side of the grill and pushing down on the shelf assembly until level with the grill. (See Fig. 8) Side Shelf Tabs Fig. 8 2. Lock the side shelf in place by inserting (2) hex head screws in the side burner. (See Fig. 9) NOTE: A power screwdriver extension is needed to insert screws. Screw Holes 3. Install burner and cap. (See Fig. 10-11) 4. Install grate over burner.
Built-In Instructions The Electrolux Grill can be installed as a built-in grill. If installed as a built-in grill, the outdoor cooking center must be constructed of non-combustible material. PLANNING AND DESIGN Start by identifying the number and size of components you want to include in your outdoor cooking center. Countertops must be constructed of non-combustible, outdoor-safe materials. Consider outdoor lighting to illuminate after-dark grilling.
Built-In Instructions Note: Make Sure To Use Non-Combustible Material For Construction Note A: Wire & Plumbing Cutout Left & Right Sides 10 x 15 cm Opening Minimum GFI Electrical Outlet For Rotisserie Motor 2 cm Required igniter Cutout Note A* Top 5 cm 10 cm A 15 cm Side Cutout View C Front B Open Space Minimum Clearance To Open Hood 12,5 cm 4 cm 90 cm Max Mi 70 c nim m um 2 cm 2 cm Max Max 3.
Gas Requirements GENERAL INFORMATION Never attach an unregulated gas line to the appliance. Connection to an unregulated gas line can cause excessive heat or fire. Verify the type of gas supply to be used, Liquid Propane or Butane (L.P.). NOTE: Always have a qualified service technician perform difficult conversions or modifications. All pipe sealants must be an approved type and resistant to the actions of L.P. gases. Never use pipe sealant on flare fittings.
Pre Operation Leak Testing GENERAL INFORMATION Although all gas connections on the grill are leak tested prior to shipment, a complete gas tightness check must be performed at the installation site due to possible shifting during shipment, installation or excessive pressure unknowingly being applied to the unit. Periodically check the whole system for leaks and immediately check the system if the smell of gas is detected. BEFORE TESTING Do not smoke while leak testing. Extinguish all open flames.
Lighting the Grill BEFORE LIGHTING Do not attempt to “Light” the grill if the Important! Before Lighting... odor of gas is present!! Check the gas supply line for cuts, wear or abrasion. Always keep your face and body as far away from the grill as possible when lighting. GRILL BURNER LIGHTING Fig. 15 Lighting the Grill with electronic igniter 1. Make sure tall control knobs are in the “OFF” position. 2. Open the gas supply valve located on top of your L.P. tank. ATTENTION: When turning the L.P.
Using the Grill GRILL LOCATION Do not use the grill in garages, breezeways, sheds or any enclosed area. Never operate the grill in enclosed areas as this could lead to a carbon monoxide buildup, which could result in injury or death. Place the grill on a level surface. Avoid moving the grill while it is operation. NOTE: The grill will operate best if it is not facing directly into the wind.
Using the Rotisserie & Side Burners (Optional ROTISSERIE KIT to use with back infrared burner must be purchased separately) The grill rotisserie system is designed to cook items from the back using infrared heat. The rotisserie burner is an infrared type which provides intense searing radiant heat. Preferred by chefs over other cooking methods, this intense heat sears in the natural juices and nutrients found in quality cuts of meats.
Using the Rotisserie & Side Burners ROTISSERIE LIGHTING Open the lid. Push and turn the control knob for the rotisserie counter clockwise to the “HIGH” position. Wait 5 seconds. Then press and hold the electronic igniter button. You’ll hear a snapping sound. If the burner does not light in 4 seconds, turn the control knob to OFF and wait 5 minutes before trying again. Once lit, turn the control knob to the desired setting. (See Fig.
Care and Maintenance DRIP TRAY The drip tray located below the grill, inside the cart, should be cleaned periodically to prevent heavy buildup of debris. NOTE: Allow the drip tray to cool before attempting to clean. Important: Do not leave the grill outside during inclement weather unless it is covered (cover sold separately). Rain water can collect inside of the grill, the grill cart or the drip tray if left uncovered.
Troubleshooting Your Grill GENERAL TROUBLE SHOOTING You should inspect the burners at least once a year or immediately if any of the following conditions occur: • The smell of gas. • Flames appearing mostly yellow. (some yellow at the tips is OK) • The grill will not get hot enough. • Burners make a snapping noise. • The grill heats unevenly. SPIDER AND INSECT WARNING Spider and insects can nest in the burners of this or any other grill and cause the gas to flow from the front of the burner.
Troubleshooting Your Grill PROBLEM SOLUTION Grill will not light with a match or low heat with dial set to "High" position. • Is your gas supply fully turned on? • Is there gas in your tank? Check your gas level. • Shut off gas supply, disconnect gas line at tank, reconnect the line to the tank. • Make sure all the knobs are in the off position, then open the gas supply valve on the L.P. tank very slowly 1/4 turn, then open fully (at least two full turns). Check flame height again.
Warranty LIMITED LIFETIME WARRANTY Frigidaire Grills have a limited lifetime warranty on all stainless steel panels, limited 3 years on stainless burners, a limited 1 year warranty on all other parts and limited 1 year on labor. In the U.S.A., your appliance is warranted by Electrolux Home Products North America. We authorize no person to change or add to any of our obligations under this warranty.
